Getting e-juice in your mouth happens for various reasons, and here are some of the common ones: Hardware problem - A malfunctioning or damaged device can lead to leaking. Overfilling the tank - Liquid in an overfilled tank will find a way to escape. Unfortunately, this surplus gets straight into your mouth.
Why does my e-juice get in my mouth?
Some of the most common reasons why you get e-juice in your mouth is listed below: You may be overfilling your tank. You might be trying to inhale the vapor too fast. You might be holding the vape at the wrong angle. Your tank might have a leak. You might be using the wrong type of e-juice i.e. low-quality.
Is it bad to get vape juice in your mouth?
Why does my vape hit my lips when I vape?
What's going on when you vape e-juice?
Why does my e-cigarette leak?
There are a variety of things that can cause your e-cigarette to leak. You may have missing or damaged O-rings inside of it. Or you may have the tank tightened entirely too much. You may even have low quality e-juices that are the source of your leak.
Can vaping cause damage?
It can cause damage to the e-cigarette itself, and it can make vaping unpleasant for you since you’ll spend most of your time worrying about the e-juice that is leaking everywhere as opposed to the vapor you’re creating. It can also send e-juice squirting into your mouth if you aren’t careful.
Reason #1 – A Dead Coil
- Your coil may be done dancing if it is giving you a lot of spit back. They only last so long, after all, even under the best circumstances. Don’t expect that coil to last a month or two. A week or two is about as long as you should use a coil for. The kind of E-fluid that you use can have an effect o…
Reason #2 – Bad E-Fluid
- “Bad” may not be the right word. It could just be that you’re using the wrong kind of E-fluid. Your tank’s or device’s performance depends largely on what kind of E-liquid you use in it. You might be asking for trouble if you have a sub ohm coil and you are using an E-fluid that is high in PG. They tend to be watery and thin. They flow right through your coil. On the other hand, E-fluids with hig…
Reason #3 – Did You Over Prime The Coil?
- This is a common mistake and happens frequently; particularly if you’re not familiar with a tank or device. Correct coil priming is executed by applying a bit of E-liquid to the wicking ports. Just drip, down the center of it, a few drops. Some will require less juice, some more. You don’t want build-up in the chimney, you just want to saturate the cotton well. The solution – if you do happen to o…