To use it you need to: Remove the mouthpiece from the battery and press down on the plunger to extend the dart. Dab the dart into your wax to collect a small pea-sized amount.
Full Answer
What is the puffco plus vape?
The Puffco Plus is the Peak’s ultraportable little brother. If you’re unfamiliar with wax pens or concentrates in general, then take a look at this Quickstart guide to get up to speed with your Puffco Plus. As with any brand new vape, let’s charge it up before its first use.
How to use the puffco peak vaporizer quickstart guide?
Puffco Peak Vaporizer Quickstart Guide. 1 Puffco Peak Quickstart: What’s in the box. 2 Charge it. 3 Fill the bubbler. 4 Attach the bubbler to the base. 5 Run a test session. More items
How do I use my puffco plus?
How do I use my Puffco Plus? Click the cloud button 5 times consecutively to lock and unlock the unit. Click the cloud button 4 times consecutively to change the temperature setting. (Green - Low, Blue - Medium, White - High) For regular use hold the cloud button down and inhale.
How much puffco do I put in my chamber?
The most efficient way to load your Puffco chamber is with a single-use amount, which is about 0.2-0.3 grams. When using this amount, set your Puffco to Sesh Mode (information on this below) and run the chamber empty. You only want to run this setting three times before adding more wax.
How do you use the Puffco DAB pen?
0:121:50How to use the Puffco Plus - YouTubeYouTubeStart of suggested clipEnd of suggested clipPress down firmly while twisting to screw in the mouthpiece. Press the button four times quickly toMorePress down firmly while twisting to screw in the mouthpiece. Press the button four times quickly to cycle through the three temperature settings. Blue is the lowest setting. Green is medium.
Why is my Puffco pen not working?
Sometimes even the smallest bit of debris can cause a bad connection which stops the pen from working at it's full potential. To start, we recommend that you try cleaning the gold connection pins between the battery and atomizer to alleviate any connection issues that may be occurring between the two.
What do you put in a Puffco pen?
The Puffco Plus is able to vaporize most, if not all, categories of concentrates, including wax, budder, shatter, rosin, live resin and oil.
How do you turn on a Puffco vaporizer?
To turn it on, click and hold the button for three seconds, until it vibrates and the band light turns white. Click once to bump the temperature up a level, all the way up to the highest temperature (White Light). Double click to activate the heater and let it run a full cycle.
Why is my Puffco pen blinking?
If the pen is not fully charged the battery will display a white light when the battery is attached. Once the pen has completed charging, the light will blink green and turn off.
Why is my Puffco pen blinking blue?
The Red-Blue-Red-Blue flashing response from your Peak Pro is a sign of a chamber connection error. Please try first removing and cleaning the chamber from the device.
Is Puffco a vape?
The Puffco Plus is a portable vape pen and is the latest addition to the growing line up of Puffco products with a coilless ceramic chamber and a built-in dab tool.
Can you smoke diamonds in a Puffco?
Just like any other concentrate, you'll need to heat up diamonds before you get high. This concentrate can be consumed by smoking, vaping or dabbing. You'll want to invest in some high-quality equipment to maximize your concentrate experience. We highly recommend grabbing a Puffco Peak, DaVinci IQ, or Pax 3 Kit.
How hot does a Puffco pen get?
Heating and Temperature Regulators As far as temperature control goes, there are three different settings to choose from, and they are color coded. Green is 580 degrees, blue is 650 degrees and white is 720 degrees Fahrenheit.
Why won't my Puffco heat up?
If the battery is functioning as intended and your chamber won't heat you may be experiencing a connection issue. In this case we always recommend cleaning the gold connection pins located on the top of the battery and the underside of the chamber.
Why does my Puffco blink red and blue?
The red-blue flashing response from your Peak Pro is a sign of a chamber connection error. Please try first removing and cleaning the chamber from the device. Submerge the chamber in 90%+ Isopropyl Alcohol for 20 minutes. Never use water – 99% ISO only!).
How do you change the temperature on a Puffco pen?
Click four times to cycle through each temperature setting and land on the Blue temp setting. Press and hold the button in to activate the heater, and start your hit. Release the button when you're done.
How many dabs does a puffco peak take?
A quick tip. The Puffco Peak can chug out about 30 dabs per charge, but its battery will slowly drain if you don’t power it off manually. If you set it down after a session and don’t touch it for a while, you may come back to a dead Peak. Be sure to either power it down, or plug it in after you’re all finished with it.
How to attach bubbler to a cigarette?
To attach the bubbler, locate the small hole on the bottom of the outside of the glass and align it with the atomizer. Insert the front of the glass under the lip, and then push the back in to complete the seal. Give it a couple hits while it’s off to check the air flow.
Can you fill a puffco glass with water?
When filling the Puffco Peak Glass, less is always best. Puffco suggests filling just past the two air holes, and we agree. Any more than that, and you might get water in your mouth. Water can damage the electronic base and atomizer as well, so be sure to fill it up before you attach it to the base.
What is puffco plus?
The Puffco Plus is the Peak ’s ultraportable little brother. If you’re unfamiliar with dab pens or concentrates in general, then take a look at this Quickstart guide to get up to speed with your Puffco Plus.
How long does it take to charge a vape?
Take your Plus and unscrew it right above the button to reveal the charge connection. Screw the bottom half of your Plus (the battery) onto the USB Charger. A full charge will take roughly 30 minutes, and should last around 50 hits.
How to test a plus heater?
Screw the Plus back together and rapidly click the button five times to turn it on. Double-click to engage the heater into session mode and let it run until it times out, twelve seconds later. While it’s heating, blow into the heater to see if hot air bounces back at you. If it’s heating up, you’re good to go.
How to load puffco?
To load the Puffco Plus, unscrew the mouthpiece from the chamber so the dart is visible. Next, use the dart to collect the desired amount of wax. When you’re satisfied with the quantity, screw the mouthpiece back on and you’re good to go. The most efficient way to load your Puffco chamber is with a single-use amount, which is about 0.2-0.3 grams.
How many cycles can you run on a puffco?
After fully charging your Puffco Plus battery, you can run 30 Sesh Mode cycles on the highest temperature setting before needing to recharge. Constantly using the Puffco battery on the highest temperature setting or on Sesh Mode will drain the battery faster.
Does puffco wax pen work?
Puffco designed their wax pen for a variety of essential oils, regardless of the substance, consistency or flavors. Just make sure you’re not loading your chamber with overly runny or sappy oils or anything in liquid form. The wax pen is not designed for dry herbs either.
Can a pen clog after long use?
Although it’s not likely, sometimes the chamber will clog after long-term use. If this does happen, unscrew the mouthpiece and, while holding the pen upside down, run a Sesh Mode cycle to let any leftovers spill out (if you’re doing this inside, make sure to have something to catch the dripping byproduct).
Can you overfill a puffco atomizer?
Once your Puffco Peak is fully charged, fill the glass attachment with water before attaching it to the base - water will damage the base and atomizer! You should also be sure not to overfill the glass, keeping the water line just above the air holes.
Does puffco have a dab tool?
Puffco includes a Peak dab tool to gather your contents and place them in the atomizer bowl. Don 't overfill the container because if the residue leaks into the atomizer, it can permanently damage it.
