What is NI TI and SS in vape?
Stainless steel (SS), nickel (NI), and TI (titanium) are all wire materials. With the exception of stainless steel, which can be used in wattage mode and SS mode, they should only be used in those mods that correspond to them. They allow you to limit the temperature you vape at.
What setting should my vape be on?
As a general rule, dab temperatures are set between 315℉ to 900℉. Below 315℉ is usually too low to vaporize cannabis concentrates. And above 900℉ can release carcinogens as well as a harsh, burnt vapor.
What do the letters mean on my vape?
The wattage and voltage setting of your box MOD is generally indicated by a number followed by the letter “W” for wattage, and “V” for voltage. For example, your screen may display: “14.1W” and “3.81V,” indicating a wattage of 14.1 and a voltage setting of 3.81.
What is temperature control mode?
Temperature Control (TC) mode allows you to set a specific temperature value on your mod at which your e-juice will be vaporized. Your mod will adjust its power output according to the set temperature value so that the coils temperature will remain constant and under control.
What wattage gives the best flavor?
The sweet spot for getting a balance of vapour and flavour is around 0.3ohms. Depending on your coil choice you'll want to up the wattage from anywhere between 50 and 100 watts. Clapton and Alien coils usually take a bit more power to ramp up so you'll want to boost the wattage if you're using either of these options.
What temp should I vape e juice at?
420 degrees FahrenheitMany people agree that 420 degrees Fahrenheit or 216 degrees Celsius is the sweet spot. You get as much flavor as possible without feeling the warmth of the vapor. If you want to add even more flavor, try a temperature between 425 and 450 degrees Fahrenheit or 218 and 232 degrees Celsius.
What does S and R mean on a vape?
The R is for Rebuildable and the S is for Smart. I'm other words when you're using a premade coil that u buy to pop into your pod or sub-ohm tank then u would keep it on “S” which basically predetermines the recommended wattage for that particular coil.
What wattage should I vape at?
On the contrary, even 10 watts is sufficient to guarantee a satisfying vape, which may be ideal for new vapers. As you become more experienced, it's safe to say that vaping starts to shine between the range of 40 and 50 watts.
What does R mean on a vape?
R is resistance, measured in ohms. Many vapers are familiar with the term “sub-ohm vaping,” meaning vaping with a total resistance of less than one ohm. The amount of resistance in your circuit obviously has an impact on the amount of power you are getting out of your device.
How do I get the best flavor out of my vape?
ContentsBest Wattage and Temperature Settings For Flavour.Reduce Your Airflow.Choose Your Coil Carefully.Wicking and Coil Materials Matters.Think About VG:PG Ratios.Below-Coil Airflow Boosts Flavour.Choose a Narrower-Bore Drip Tip.Keep Your Wicks, Coils and Tanks Clean.More items...
What is TC NI mode vape?
TC mode is like a car that allows you to put the pedal right down, but you can also gently tap it to move the vehicle ahead slowly. With some mods you can set a custom curve, allowing you to control the speed and rate at which a coil is ramped up. This is a huge leap forward for the vaping industry.