Power Locked mode: Holding down both the up and down buttons for two seconds will place the device in Power Locked mode. In this mode, the mod will operate normally, but you will not be able to change the power setting. This mode prevents accidental power level changes due to the buttons being pressed while in a pocket.
Why does my vape pen have a lock button?
The lock position helps to prevent the battery from turning on while in transit. This is also an important feature when carrying your pen in a purse or bag. After receiving your vaporizer, test to see if the pen is locked or unlocked. You can do this by pressing the button once.
What is power locked mode and how to use it?
Power Locked mode: Holding down both the up and down buttons for two seconds will place the device in Power Locked mode. In this mode, the mod will operate normally, but you will not be able to change the power setting.
Why does vapor lock not occur in modern engines?
However, vapor lock rarely occurs in a modern engine because of the use of an in-tank, electric fuel pump. This allows the pump to operate at a low point in the tank, submerged in fuel, and under a lower temperature than the older mechanical pump located in the engine compartment. Also, in a modern fuel delivery system fuel is pressurized.
How do I know if my fuel delivery system is vapor locked?
As the engine cranks, spray a shot of starting fluid through the throttle valve. If the engine seems to catch while spraying the starting fluid, there's a good chance the fuel delivery system is vapor locked. After your warmed engine stalls, pull to the side of the road. Open the hood.
How do you unlock the power lock on a vape?
0:171:02How to Lock and Unlock a Uwell Crown 4 / IV Mod! - YouTubeYouTubeStart of suggested clipEnd of suggested clipSo let's unlock it hold down the power button and the UP. Button at the same time.MoreSo let's unlock it hold down the power button and the UP. Button at the same time.
How do I unlock my Smok vape?
Unlock your device, which you can typically do with 5 clicks in rapid succession. Most vapers simply get in the habit of clicking the button rapidly until the indicator light turns on, so you don't have to literally count out five clicks every time.
How do you turn off power lock on Smok Nord?
How To Operate the Smok Nord X Pod KitPress the fire button five times rapidly to power the device on/off.Press the fire button three times rapidly to lock/unlock the device.
How do you unlock Watts on Smok?
Three clicks of the fire button/bar allow you to switch vaping modes (wattage or TC of Ni, Ti, SS). Pressing both adjustment buttons at the same time locks and unlocks the wattage.
How to unlock a vape pen?
To unlock the vape pen rapidly (we mean fast!) press the button 6 or more times until the button flashes. Disregard any set number of presses you may read in the instructions. If you do not have the timing or the rhythm down or skip a beat, this will alter the number of times you need to press the button. I just press the button until it flashes.
How to lock a pen?
To lock the pen, simply follow the same instructions as unlocking the pen. Once the button flashes, the pen should be in locked position and the button will not light when pressed down. So please don't panic when you first get your pen and the button doesn't light when pressed.
Why is the pen lock position important?
The lock position helps to prevent the battery from turning on while in transit. This is also an important feature when carrying your pen in a purse or bag. After receiving your vaporizer, test to see if the pen is locked or unlocked. You can do this by pressing the button once.
mexus
Hello! I just got my first DNA vape today - Lost Vape Triade How do I enable disable stealth mode from the vape itself (tired all possible combination Power + UP/Down in normal and locked state - nothing worked). I can enable stealth mode from Escribe - but this is not OK for me? Also how can I lock the power settings? Like not having it change in my pocket? Also is there a key lock or something. Thanks!.
retird
As we know there is many ways to design a Theme for the 250C board. I don't know how factual this article is, as I don't have a Triade nor do I know about their theme design, but I ran across this article: https://spinfuel.com/lost-vape-triade-dna250c-300w-mod-review/ From this article it says in part:
DNA250C Modes Available to the Lost Vape Triade
Locked mode: Pressing the fire button five times with less than .7 seconds between presses will cause the device to enter Locked mode. In Locked mode, the device will not fire and the output power will not adjust accidentally. While in Locked mode, the screen will be off, except that pressing a button will show “Locked, Click 5X”.
retird
I thought that article was probably not correct. There is a stealth mode in the Theme I use with my 250C devices. Here is a screenshot of one screen in Theme Designer. So with the 250C you turn Stealth on and off from the menu. I think Stealth only works when firing the device as you need to see the screen to use the theme.
mexus
I thought that article was probably not correct. There is a stealth mode in the Theme I use with my 250C devices. Here is a screenshot of one screen in Theme Designer. So with the 250C you turn Stealth on and off from the menu. I think Stealth only works when firing the device as you need to see the screen to use the theme.
retird
I am not versed in designing Themes but if possible and if the functions you want are available for a theme they would need to be designed into the Theme. You might look at the design of your theme and see if Stealth is already there.
mexus
Thank you. I have saved the theme and installed one that supports at least stealth mode (from settings). Maybe there are no key shortcuts in DNA 250C for this?
What is vapor lock?
Vapor lock occurs when fuel overheats and vaporizes in a fuel line, carburetor or fuel injector, disrupting the correct air-fuel ratio. Although common in older vehicle models, it wasn't until the appearance of the modern fuel injection system that vapor lock became more prevalent in carbureted engines.
What causes vapor lock?
Several factors can contribute to vapor lock: High underhood temperatures. Fuel lines next to or touching hot engine components. Lose of fuel delivery system pressure or flow (volume) (this may be caused by a restricted fuel filter or insufficient voltage to the fuel pump) Fuel pump next to hot operating engine.
How to start a car with a vapor fuel pump?
After your warmed engine stalls, pull to the side of the road. Open the hood. Place a bag of ice on the fuel line between the fuel pump and carburetor and the one that connects to the fuel pump to bring down the fuel line's temperature and allow vapor fuel to condense. After a few minutes, try starting the engine.
What to do if fuel pump is not plugged?
Make sure the fuel pump and fuel filter are not restricted. If your fuel system has a return line, make sure it's not plugged. Heat shield fuel lines, pump and carburetor with special metal plates, or insulating tubing. You can also find fuel injector wrappers that reflect heat away.
What does it mean when your mod is too hot?
Temperature alert: if the internal temperature of the device is over the supported temperature, the output will shut off automatically and the screen will display "Device Too Hot". This means you have used the mod for too long, and you should shut it down and wait for some time and then power on again.
What does "over X seconds protection" mean?
Over X seconds protection: the device will have some protection for safety use. When the power button is pressed for over the supported time protection, the output will shut off and the OLED screen will display "Over Xs Protection".
What does "no atomizer" mean?
1. "No Atomizer" or "Check Atomizer". No atomizer / check atomizer alert: when the device does not detect an atomizer, the OLED screen will display "No Atomizer" or "Check Atomizer". ◆ Check the 510 electrode of your tank. Most of the devices have self-adjusting 510 connectors, but some have manually adjustable ones.
What does "check USB" mean?
Check USB alert: when the voltage of the USB charger is equal or greater than the supported voltage, the OLED screen will display "Check USB" after inserting the USB Cable or vaping.
