Why does my pen blink 3 times when I try to hit it?
3 - VAPE PEN BLINKING 3 TIMES It's common for some vape pen batteries to stop working because of a short circuit, and this is usually indicated with the light blinking 3 times. It can also mean there is a chance there is not a good connection being established with the vape cartridge and battery.
Why does my vape blink when I press the button?
This is often caused by a loose battery. If the battery is not screwed in properly, it won't be able to fully charge and the indicator light will continue to blink. To fix this issue, unscrew the battery and re-screw it back in to make sure everything is firmly connected.
Why does my Smok vape pen 22 Keep blinking?
Resistance protection: when the atomizer resistance is lower than 0.1 ohms or higher than 2.5 ohms, the LED light will blink 4 times and the battery will automatically shut down the output. 3. Low voltage protection: when battery capacity is lower than 3.
Why does my pen blink when I try to hit it?
If the issue is a leak, turn off your battery and take a Q-tip dipped in rubbing alcohol and clean where the battery and cartridge meet. Make sure to dry them before screwing them back together. Another reason your battery may be flashing is because it may be dead and needs to be charged.
How do you fix a short circuit on a vape?
Here are a few things to try to resolve atomizer short:Make sure the batteries are charging them properly by putting them in a separate charger.If using an RDA/RTA, check and see if the coil is touching the cap or deck.See if there are any breaks in the coil.Ensure that the coil is fully screwed into the tank.More items...•
Why does my vape light up but not hit?
A disposable vape uses an airflow sensor to detect when you puff. Sometimes, a disposable vape that doesn't hit isn't working because the airflow sensor isn't sensitive enough or because the sensor is blocked by condensation inside the device.
Why is my Smok vape pen 22 not working?
SMOK Vape Pen V2 Not Hitting Dissemble the tank and remove the atomizer coil. Use a cotton swab to clean the threading at the top of the SMOK Vape Pen V2 and to absorb any e-liquid that may have found its way under the atomizer coil. Reassemble the tank and try again.
How do I reset my Smok vape?
Reset the tank - You can 'reset' the tank by removing it from the mod, checking the screws are tight and pressing the fire button. Then re-attach your tank and select “n” when you are asked if it is a new coil.
How do I get my vape to stop blinking?
Charge the Battery: Simply plugging it in to charge the battery might stop the blinking in just a moment. Replace or Refill the Cartridge: If a lack of e-liquid was the problem, replacing or refilling your cartridge should do the trick.
How do you fix a cart that is not hitting?
The holes in the cartridge may be clogged with oil. Try warming your cartridge with a hair dryer (lowest heat setting) or by rubbing it between your hands to warm up the oil and change its viscosity. You can also poke a toothpick or safety pin gently in the hole to help de-clog it.
Why won't my vape pen heat up?
If your pen's atomizer isn't heating, first to make sure that your battery is charged and turned on. Then check the connection between the battery and your atomizer or cartridge. If it is dirty, clean it with a cotton swab. You will also want to make sure this connection isn't overtightened.