Take the tank off and check the seal as well. I checked mine and the bottom seal had crimped causing it to sit outside the recessed point. Honestly it’s nothing to fret about - it unscrews just fine and if you tighten the base just a little too much then this can occur.
Full Answer
Why is my vape juice coming out of the tank?
Beyond that you could be flooding the coil from overpriming it and if it's excessively flooded trying to vape the juice will just result in heating it and causing the juice to exit via bottom airflow. You could also flood the tank by using high PG e-juice in a sub ohm coil, and pulling too hard at low wattage with closed airflow.
Why does my vape spit back when I vape?
Wait a minute or so and then vape as usual. Other possible reasons for spit back may include the following: using high PG e-juice in conjunction with a sub ohm coil, chain vaping from a tank which gets fairly hot as the heat thins your ejuice, a coil which is wicking the cotton too quickly.
Why is my vape gurgling?
One of the simplest reasons for gurgling or spit back is a beginner attempting to vape 70VG or higher e-juice with a high resistance coil intended for mouth to lung. The e-juice in that instance is too thick for your low wattage device and coil, therefore the e-juice doesn't heat sufficiently to turn into vapor.
How to contact geekvape about a leaky coil?
Geekvape official will just give you a canned response asking you to email April. They should have designed the coil to insert down through the top and contact a metal plate at the bottom like the Joytech AIO. It would have been 100% leak proof that way. They are aware but every person that goes to them with the issue reports the same thing back.
Why does my vape keep switching off?
Weak battery. Your battery may simply just be running out of power. Try switching to a fully charged battery and see if it makes a difference. If you are using a variable wattage device, try turning up the power.
Why is my geek vape not hitting?
Geek Vape Aegis Solo Not Working If nothing happens when you attempt to use the Geek Vape Aegis Solo, it's likely that the battery is dead or that the device is locked. To unlock the device, press the fire button five times quickly. If the device still doesn't work, try charging the battery.
How do you fix Aegis geek vape?
How to Fix Problems With the Geek Vape Aegis SoloTry a different USB cable. ... Try a different computer or a different USB port on the same computer. ... Make sure that the battery is secure and installed with the correct orientation. ... Replace the battery if none of the above solutions work.
How do I reset my vape geek puffs?
Change Mode: 3 clicks of the fire button then using up down buttons to scroll. Once in Output adjustment mode, you can scroll down to adjust coil resistance and reset puff count by pressing the fire button.
How do I reset my Geekvape Aegis boost?
When you highlight power mode you can click the fire button to highlight the resistance then lock it by pressing the up button. Clicking the fire button again will highlight the puff counter and the up button will reset it to zero.
How do I get my vape to work again?
The best way around this problem is to vape with one of your fingers around one of the inlet vents. This increases the airflow pressure and might get the sensors up and working again.
What is bypass mode on Aegis?
Bypass modes are a great way to remove wattage from the equation. In bypass mode, the vape bypasses the wattage. Instead, it relies on the highest voltage that it can get from the battery. This means you get more intense hits as well as quicker clouds of vapor.
How do you fix a geek vape without atomizer?
1:156:58How to fix a no atomizer message on your vape - YouTubeYouTubeStart of suggested clipEnd of suggested clipAnd make sure you can remove the base without the tank leaking. If not then decal the vape juice outMoreAnd make sure you can remove the base without the tank leaking. If not then decal the vape juice out of the tank. First. Now check that your coil is screwed into the base of the tank.
How do you clean a geek vape?
In that case, you can follow these steps for deeper cleaning.Remove wicks from coils.Dry burn your coils lightly (don't let them glow too much)Remove atomizer from your mod.Place under running water.Brush them lightly with a toothbrush or a coil cleaning tool.Rinse once again.More items...
How do I unlock my geek vape?
Geekvape Aegis Max kits are shipped in locked position. This means that you need to unlock your vape by pushing the button 5 times quickly to unlock. Once it is unlocked, it will blink to confirm it is unlocked and will work. The other simple issue is that it is not charged.
How do I reset my Geekvape boost pro?
Hold down the UP and DOWN button together to lock the settings. Hold DOWN & Fire buttons to reset puff counter. Three Clicks of the FIRE button locks the mod from firing.
What is stealth mode on vape?
Stealth vaping is the act of vaping in a discreet manner. Using small vapes that generate smaller plumes of vapor, the user can regulate the exhaled-puff barely visible. This form of vaping works best with concealable devices that have low power and have a tight MTL draw, often called stealth vapes.
How do I unlock my vape geek?
Geekvape Aegis Max kits are shipped in locked position. This means that you need to unlock your vape by pushing the button 5 times quickly to unlock. Once it is unlocked, it will blink to confirm it is unlocked and will work.
How do you unlock geek in vape Z?
Press the fire button five times to unlock it. If the Aegis Hero still isn't hitting, the screen should display an error message telling you what the problem is. If you see the message “Battery Low,” you need to charge the device.
How do you unlock Geekvape Z?
Geekvape Aegis Legend 2 Externals Rather than pressing the fire button 3 times or having to do some weird button sequence, all you need to do to lock all the buttons is push the small slider up to lock and down to unlock.
How do you reset Aegis hero?
Aegis Hero Button Combinations Press the adjustment buttons to select mode and hold the fire button down to select. Clear Puff Counter: press the fire button and down the adjustment button. The puff counter will be highlighted. Press the down button again to clear the puff counter.
Update Software?
I have an Aegis X, and I was wondering if you should ever update a vape or if there is even an update for the thing?
ZMax M series coil
I’ve been using the zmax tank for 6 months or so and have generally loved it, but I noticed my coils suddenly went from lasting 900-1200 puffs to 100-200. When I first got it, I tried all coils and settled on the triple coils as my go-to. The boxes did have a spelling error and were sold as “trible” not triple.
Can I charge me Obelisk 120FC with a phone charger?
I just got the aforementioned vape kit and I had to research a lot already when getting one, so it completely slipped my mind that the fast charger is not included.
Brucebruce19 New Member
Hi I'm new to this forum but I have a question that I'm hoping I'm not the only magical one is dealing with. I bought a geek vape boost about a month ago n personally I love it. But my first unit had the first coil that came with it installed and after priming it with juice n than using it.
Figs Super Member ECF Veteran
I like my boost, but yes I’ve had the same. Filling it is a pain, and I always spill juice in the process. Mine does the same thing you describe when I “overfill” it. Not really overfilled, but simply filled to the top. After a month I am running out of patience with the thing.
dennism Ultra Member ECF Veteran
I'm very disappointed in my Boost, Geekvape makes excellent mods, but terrible pods. It's gotten to the point that Geekvape is on my don't buy list. How they designed such a terrible pod is beyond my understanding.
Fredman1 Vaping Master ECF Veteran
Yep I have the same thing going. It leaks liquid through the coil. Some coils leaks more and quicker than others to. Others starts off well and starts leaking later. Very irretating. I emailed Geekvape and waiting to hear from them. I want to know what they are doing about it as i'm sure they're aware of it.
Brucebruce19 New Member
Looking at the pod it looks like the oring tests inside of a dip so to speak instead of against something to block the leaking. This is clearly a design issue as the pod has many of them.
dennism Ultra Member ECF Veteran
IMHO Geekvape should be ashamed of them selves, foisting this very bad pod on the vaping public. When I saw Geekvape Aegis Boost, I thought this will be great, as far as vaping is concerned I couldn't have been more wrong.
Brucebruce19 New Member
I love my aegis x but they royally messed up this pod. I'm hoping the rba for it will make up for how bad it has been.
Why does my battery sound like it bounced?
Totally in agreement with you...If it only happens when it is put down on a hard surface then it sounds as if a battery bounce due to a springy contact.
Is it unusual to have something substantial enough to prevent contact?
Something substantial enough to prevent contact, but not substantial enough to be visible is highly unusual, but I'm certainly not in a position to tell you it didn't happen Steve. In any case, it's a trivial matter to clean the contacts and find out.
Can liquid sit on battery contacts?
That makes more sense for sure. Some liquid can sit on battery contacts and be pretty much invisible. Can even be a color similar to the contacts. I was thinking more of dried accumulated gunk.
Geek Vape Aegis Product Overview
- The specific product we’ll be covering from the Geekvape Aegis range is the Geekvape Aegis Legend. It’s a box mod with a stylish and modern design that will definitely serve you well.It features a colored display screen that will provide information like the current wattage, and it also has a function button to help you interact with it. Venting holes on the base of the Geekvape Aegis Legend help to keep it cool while in use, and you can charge it …
Product Parameters
- According to the details in the Geekvape Aegis user manual PDF, a range of specific parameters apply to the Geekvape Aegis Legend. One of the most important is the maximum output duration. It can output for 10 seconds at a time, so keep that in mind while you’re vaping. Other key features include the charging voltage and amperage. It needs 5 volts and 1 amp, so make sure to charge it according to these parameters. There is also a maximum v…
Usage Instructions
- There is an outline from the Geekvape Aegis user manual that guides you through how to vapeusing it, so we’ll cover the main points here: - To turn it on and off, press the fire button 5 times quickly - To select a mode, give the fire button 3 presses - To switch modes, tap the plus and minus button and the fire button - To set the resistance level...
Buy Geekvape Aegis Products
- Now that we’ve summarized the Geekvape Aegis Legend user manual, we’ll take a look at some of the other Geekvape Aegis products that we think are worth your attention. We’ll give you a brief overview of each one and then a link where you can find out more. That way, you’ll be able to make an informed choice about which one is right for you.
Conclusion
- Now that you’ve seen our summary of the Geekvape Aegis Legend user manual, you should be aware of all the essential information about that product.You should also be familiar with the features, benefits, and drawbacks of the three other Geekvape products we’ve included in this article. Hopefully, this information will help you to make a choice about Geekvape and which of their products you’re interested in. There is more information available onli…