What is Ijoy capo 216 srda kit?
IJOY CAPO 216 SRDA KIT is the first and smallest dual 20700 Squonk KIT! Long battery life, stylish, personalized fire button and adjustable buttons, convenient battery cover with lock design, OLED large display, 5-216W high power adjustable, simple and safe operation.
What are the common problems with modmod or vape?
Mod or vape can't fire. 1. 510 connector shorts out. 2.The resistance of coil you are connecting is lower than 0.1Ω Problem 2. Can't read the resistance correctly, show "ohms too low" or "ohms too high" 1. Screws are not tight down. Problem 3. The voltage does not change while vaping 1. PCBA is damaged. 1. Please try to clean the 510 connector 2.
What are the common problems with vape coils?
2.The resistance of coil you are connecting is lower than 0.1Ω Problem 2. Can't read the resistance correctly, show "ohms too low" or "ohms too high" 1. Screws are not tight down. Problem 3. The voltage does not change while vaping
What to do when the voltage does not change while vaping?
The voltage does not change while vaping 1. PCBA is damaged. 1. Please try to clean the 510 connector 2. For the problem of resistance detection error, please take off the tank ,click the fire button, and place that tank back on 3. Please make sure screws are tight on tank if you are using the RBA coil on your mod. 4.
Upgrade IJOY Mod Guide
1、 Take out the batteries 2、 Make USB cable connect the computer first 3、 Hold the fire button and then make USB cable connect your device 4、 Open updating Software, then you can see the computer indicate as below: 5、Click “choose” to choose the file for the device update，then you can see the computer indicate as below: 6、Finally, click “Update” to finish updating Tips: Take out the batteries and make USB cable connect the computer first. Then hold the fire button and make USB cable connect your device at the same time..
Can not find the corresponding product upgrade software?
If you can not find the corresponding product upgrade software, because the product upgrade software has not yet released, if you have any suggestions to upgrade the product, you can contact Livechat staff.
What if the device cannot turn on after upgrading? Or failed to upgrade?
If the device cannot turn on after upgrading, firstly, please take out the cells, wait for a few minutes, then install the battery. If you failed to upgrade, you can also change other USB cables or computers for a try. Tips:1. All upgrade software only applies to windows7 system 2. The software can be upgraded repeatedly
