A couple of different avenues you can try. Try soaking in very hot water to see if that will loosen the vacuum seal created by the dry tank (try not to ever vape it dry) or Soak the tank in vodka or alcohol.
Full Answer
How to unscrew a stuck vape tank?
If you have a pair of rubber gloves, simply wear them to get a better grip on your tank. This works like a charm and I know a lot of vapers who’ve purchased a pair of rubber gloves simply to unscrew stuck tanks. Garden gloves work, but it fits hands a bit loose, lessening the stability of your grip.
How do you get THC out of a vape pen?
This option largely depends on what kind of vape pen you use, but often you can pry them open with a little careful effort. Pull apart the various elements using small tools (needle-nose pliers, screwdrivers, etc.) until you gain access to the concentrate. Use a toothpick to smudge the residual THC out, and dab into a pipe or on to a blunt paper.
How do you open a vape pen?
This option largely depends on what kind of vape pen you use, but often you can pry them open with a little careful effort. Pull apart the various elements using small tools (needle-nose pliers, screwdrivers, etc.) until you access the concentrate.
How do you get a vape out of a tight spot?
Try wrapping your shirt tail (or the end of a clean t-shirt) around the stuck part of your vape, and possibly around the part you need to twist. Use the soft cotton fabric to ease the pain of ripping flesh when you try to wist so that you can safely grip the vape even tighter.
How do I unscrew my vape tank?
Rubber gloves: Put on a pair of washing up gloves and try to unscrew the tank with them on. They increase grip and make it much easier. Rubber bands: Wrap a rubber band around the metal part of the tank. The increased grip will make it easier to unscrew in your hands.
How do you disassemble a stuck vape tank?
Your best bet for unlocking that stupid stuck vape tank is a vice grip or a pair of locking pliers which are easier to wrench closed and hold closed while you try your best twisting maneuvers. also, look for pliers with rounded inner teeth that will fit onto your vape better than straight-edged pliers.
How do you get a stuck tank out of a Mod?
All you need is to run the vape tank under falling hot water for some minutes, two to five at most. If you're using a mechanical mod (mech mod) remove the batteries and submerge your mod in a mixture of hot water and vinegar. Now, don't mistake “hot water” for boiling water. The latter can break your vape tank.
How do I unscrew a stuck DAB pen?
3:436:57ROHS iMini How to remove a tank that's stuck - YouTubeYouTubeStart of suggested clipEnd of suggested clipSo I was able to remove it I saw I'm pretty sure you saw how tight I cranked it down okay. So youMoreSo I was able to remove it I saw I'm pretty sure you saw how tight I cranked it down okay. So you got to put enough grip on this neck.
How do you open a Smok tank?
0:143:24SMOK Tank | How to take apart & clean - YouTubeYouTubeStart of suggested clipEnd of suggested clipIf you want to change out your coil. You hold it tight here unscrew your bottom as you can seeMoreIf you want to change out your coil. You hold it tight here unscrew your bottom as you can see there's no ring right in here always make sure it's on correctly.
How do you open a vape bottle?
To open a childproof e-liquid bottle, grip the bottle with one hand, then push the cap downwards and twist anticlockwise. It might take a bit more force than you'd think! You might need to repeat the downward push/twist motion a couple of times to finally get the cap loose.
How do you open a Smok vape?
1:032:19Smok Nord Unboxing & Setup - YouTubeYouTubeStart of suggested clipEnd of suggested clipFind the fill port on the side and lift the cap fill. It up with your favorite e-juice. Today I'llMoreFind the fill port on the side and lift the cap fill. It up with your favorite e-juice. Today I'll be using mango buy salt shaker. Once your pot is full pulls the cap push the pod into the device.
How do you remove a Smok coil?
1:215:44How to change coils on SMOK Alien TFV8 TFV12 Series Vape Tanks + ...YouTubeStart of suggested clipEnd of suggested clipWith the glass now gone we can unscrew the coil from the chimney turning counterclockwise. If youMoreWith the glass now gone we can unscrew the coil from the chimney turning counterclockwise. If you accidentally remove the bottom plate of the atomizer.
Where is the atomizer located in a vape?
Housed within the vape tank, an atomizer head contains a coil of thin wire and wicking material. We will go into the finer details a little bit later, but the atomizer creates vapour.
How do you smoke vape oil without a vape?
1:332:23*EASY*how to vape without a battery/ pen/boxmod - YouTubeYouTubeStart of suggested clipEnd of suggested clipDevice your cartridges your vape cartridge. You're gonna stake the black wire into the hole. AndMoreDevice your cartridges your vape cartridge. You're gonna stake the black wire into the hole. And then once you get that and you're gonna use the red wire and touch it to the side of the thing.
Why is it hard to pull from my vape?
One of the most common reasons for a cartridge to stop pulling is due to the oil being too thick. This may cause the holes in the cartridge to become clogged and make it hard to pull. In the event that this happens, first, check if your cartridge is glass or plastic.
How do you open a Smok vape?
1:032:19Smok Nord Unboxing & Setup - YouTubeYouTubeStart of suggested clipEnd of suggested clipFind the fill port on the side and lift the cap fill. It up with your favorite e-juice. Today I'llMoreFind the fill port on the side and lift the cap fill. It up with your favorite e-juice. Today I'll be using mango buy salt shaker. Once your pot is full pulls the cap push the pod into the device.
How do you take apart a Cerberus tank?
1:325:30How to replace a geekvape cerberus coil. - YouTubeYouTubeStart of suggested clipEnd of suggested clipAnd you grab the bottom of the tank. And the top of the tank. And you just twist counterclockwise.MoreAnd you grab the bottom of the tank. And the top of the tank. And you just twist counterclockwise. The whole tank should come apart. So you pull the top off and then you can grab your glass.
How do you open a vape pod?
0:122:11How To Open And Refill STLTH And VYPE Pods - YouTubeYouTubeStart of suggested clipEnd of suggested clipThese down and then I have a vise right. Here should gently put this in here so that the lid is justMoreThese down and then I have a vise right. Here should gently put this in here so that the lid is just at the tip of the vise. So just capsule it it's got the lid.
How do you remove a Smok coil?
1:215:44How to change coils on SMOK Alien TFV8 TFV12 Series Vape Tanks + ...YouTubeStart of suggested clipEnd of suggested clipWith the glass now gone we can unscrew the coil from the chimney turning counterclockwise. If youMoreWith the glass now gone we can unscrew the coil from the chimney turning counterclockwise. If you accidentally remove the bottom plate of the atomizer.
How to unstuck a tank?
If you can’t get a piece of cloth to grip your tank properly, and you can’t source a pair of rubber gloves, rubber bands can work. Get a piece of rubber band, wrap it around your tank tightly and securely, then twist it open bare handed. The added grip is usually enough to unstuck your tank.
How to prevent a stuck tank?
To prevent stuck tanks, make sure you don’t screw it on too tight, and you clean your mod and tank at least every week. Clean the part in between the mod and tank to be sure no e-juice gets stuck and dried. After all, an ounce of prevention is worth 10mls of cure. OZ Vapour Team.
What to wear to unscrew a tank?
2. Rubber Gloves. If you have a pair of rubber gloves, simply wear them to get a better grip on your tank. This works like a charm and I know a lot of vapers who’ve purchased a pair of rubber gloves simply to unscrew stuck tanks. Garden gloves work, but it fits hands a bit loose, lessening the stability of your grip.
ThatIrishGamerHD New Member
So I got my new coil and was vaping again but I must have over tightened the tank when screwing it on.Now it's time for a refill and I can't get this stupid tank apart.I have tried rubber gloves and I put it in the freezer for 10 minutes too but it won't budge.
TheRussianVaper Senior Member
You might have to force it, sounds like the ring got bunched up and stuck, so you might have to tare it and replace the ring. PS: I always lube the rings with a little bit of e- juice, makes it a lot easier later on and they last longer.
daviedog Vaping Master ECF Veteran
The rubber gloves as stated above do work,,but soak atty in PGA first. If there is any juice on your atty it will transfer to the gloves & you are SOL..
Andromendous Super Member ECF Veteran
You can fold up the rubber gloves and wrap it around the tank, then use the channel lock pliers. Ive done this a few times. As long as something thick is wrapped around it, it wont scratch it
Katcandoo Super Member Verified Member ECF Veteran
Happens to me all the time. I keep a pair of pliers and one of those flat rubber grippy jar opener things on hand. If you don't have a flat rubber grippy jar opener thing, a rubber band wound tightly on the base will work. Hold onto the base with whatever rubber thing you have, and use the pliers to (gently!) unscrew the top. Good luck!!!
How to disassemble a vape tank?
In most cases, disassembling a vape tank is a simple task that you can perform in a matter of seconds. Simply grip the tank’s top hardware and bottom hardware in opposite hands and twist counterclockwise to loosen the threads. After you’ve unscrewed the tank, you’ll have two halves: the bottom hardware with the atomizer coil attached and ...
How to remove glass from a vape?
To remove the glass, wiggle it gently to slide it off of the silicone or rubber o-ring holding it in place. To remove the mouthpiece, lift it straight up to pop it out of its socket. Many modern vape tanks have coils that screw into both the top and bottom hardware.
How to remove stuck glass from a tank?
Just get a length of dental floss and place it in the seam between the glass and the tank’s hardware. Hold the floss tight while wrapping it around the tank repeatedly.
Why is my vape tank stubborn?
In some cases, a vape tank can simply be stubborn because the machining of the threads isn’t so good. That could be a sign that you’ve gotten a counterfeit tank, but it’s more likely just a case of subpar workmanship. Some vape manufacturers are better than others.
Why is my vape tank not moving?
One of the problems you might encounter when disassembling a vape tank is that the glass can sometimes be extremely stubborn. No matter how much you might wiggle the glass, it simply refuses to move. You don’t want to use tools or apply too much force in this case, because you’ll break the glass.
How to disassemble a Uwell Crown 3?
To disassemble the Uwell Crown 3 or another tank with a locking chimney, remove the tank’s top and bottom hardware. Take the key included with the tank and place it in the chimney under the tank’s top hardware. The key locks into the matching notches in the chimney. Twist the key to unlock the tank.
How to get rid of a stuck vape?
Try wrapping your shirt tail (or the end of a clean t-shirt) around the stuck part of your vape, and possibly around the part you need to twist. Use the soft cotton fabric to ease the pain of ripping flesh when you try to wist so that you can safely grip the vape even tighter.
What to do if your tank is stuck to the lower half of the pen?
So the very first thing you should do if your tank is stuck to the lower half of the pen or mod is to drop the batteries out, if possible. This will take all the real danger out of the situation so the only remaining risk is accidentally damaging your rig or breaking the glass tank.
What does it mean when a vape is stuck to the battery?
If your vape tank is stuck -to- the battery or mod box, then now is the time to be really careful. Remember that the stuck position means your vape could theoretically still draw power and that your battery could take damage from your un-sticking maneuvers.
How big is a jam jar pad?
Or rather, made to get jam jars unstuck and will work perfectly for your purposes. This pad is usually brightly colored and about 3-5" by 3-5", thin, floppy, shiny-plastic looking, and has little ridges or bumps over the surface.
What is the sticky pad on my mouse pad?
The back of your mousepad is covered in a sticky foam that keeps it from sliding around on your desk when you move the mouse. This sticky pad could be exactly what you need to get a good grip on the stuck part of your tank and finally twist that sucker apart.
Can you open a freezer tank if it's frozen?
In other words, if the gasket is the problem, the freezer will loosen the connection and you'll have no trouble at all opening your tank once it's frozen. just be sure not to accidentally freeze your hands to the tank when you try to un-stick it for the first time out of the freezer.
Do you need a jar opener for vaping?
Don't have a jar opener? That's okay. Even more, homes have at least one pair of (possibly forgotten) rubber gloves. Check under the kitchen and bathroom sinks, in the utility drawers, around the laundry area, and in the mop bucket if you're not sure. These are thicker than jar opener pads, but give your hands the absolute bonus when it comes to pain-free friction applied to twist that vape tank.
How to move liquid from one cartridge to the other?
You want to move liquid from one cartridge into the other, so the better the alignment, the less messy the process. Use a small bit of styrofoam (or your fingers) to hold the two cartridges upright.
Can you put a mouthpiece in the floor heat register?
As one helpful Reddit user pointed out, you can sit all the leftover mouthpiece up in an in-floor heat register. First, remove the battery, and the cartridge should sit nicely between the slats. So long as the heat is on in your house, it won’t take much for the oil to move around closer to the interior heating element.
Can you get a vape out of an empty vape cart?
It’s generally not that difficult to get a few more good pulls out of an empty vape cart. For any defective ones, you only need a hair dryer or heating pad to correct the problem. Instead of shoving that leftover and faulty THC-laden cartridge into the back of your junk drawer, use these helpful tips to get it out.
Can you break into a THC concentrate cartridge?
Breaking into your THC-concentrate cartridge is not only dangerous but desperate. If you follow the below steps, there should be absolutely no broken glass and no mess. Do not use fire to heat the device or concentrate in the device.
Can you heat a vape pens with a torch?
Vape pens and other such devices were never designed to encounter the flame from a lighter or blow torch. If you try to heat the cartridge with fire, you have to consider what else you might be heating. Plastics, heavy metals, and glues could quickly transfer from the device into the concentrate.
