how to fix yiur atomizer in yoir vape

How to Fix Check Atomizer/No Atomizer On A Pod Vape.

• 1. Clean Your Contact Points. The first step you should try if your pod vape isn’t firing or says check atomizer is cleaning out your contact points.
• 2. Check Your Contact Points for Damage.
• 3. Reseat your Coil/Pod.
• 4. Try Another Coil/Pod.

Full Answer

Why won’t my vape atomizer work?

This is especially important here because often vapers will tighten their atomizer after receiving “no atomizer” errors. In the vast majority of times, the culprit is something else. Drops – people drop their mods like they drop cellphones.

How do I fix check atomizer/No atomizer?

See our next two tips. 2. Clean Your Contact Points Over time, dirt, dust, and ejuice can collect in your 510 connector and this can cause your mod to read Check Atomizer/No Atomizer. Start by removing the tank from the mod and inspect the threading where the tank screws in for dirt, dust, or ejuice. Do the same with the 510 connector on your mod.

Can I over tighten my atomizer?

Overtightening atomizers – people often overtighten their atomizers, to the point where they break the 510 pin out and/or snap the ground wire internally. Don’t over tighten your atomizer.

What is the difference between a vape pen and an atomizer?

Vape pens and mods are the power supply unit and the atomizers are responsible for vaporizing e-liquid. The term atomizer can refer to different things. It can refer to devices containing coils or it's also used to refer to the coil inside the device.

How do I fix my atomizer in my tank?

3:256:58How to fix a no atomizer message on your vape - YouTubeYouTubeStart of suggested clipEnd of suggested clipMod. If you've done the first test and another tank on your vape mod is showing the same. MessageMoreMod. If you've done the first test and another tank on your vape mod is showing the same. Message this would indicate that the problem is with your e-cig battery or your mod. The chances are this is

How do I reset my vape atomizer?

0:000:31How To Do A Factory Reset on Your IQC Vaporizer - YouTubeYouTubeStart of suggested clipEnd of suggested clipOnce the reset is complete the vaporizer will vibrate and button lights will. Turn. Off you.MoreOnce the reset is complete the vaporizer will vibrate and button lights will. Turn. Off you.

Why won't my vape read the atomizer?

If you press the firing button on your e-cig and you see the message 'no atomizer' or 'check atomizer' it means that your vape mod is not reading the coil within your vape tank properly. It can be because of the 510 connection, the vape coil itself or the bits in between.

How do I know if my atomizer is broken?

Signs it's time to change your vape coilA burning taste. Vaping a dead coil will eventually result in an acrid, burning taste. ... Gurgling sounds. Vapes shouldn't gurgle. ... Weak or “off” e-Juice flavor. This often precedes a burnt taste. ... Low vapor production. The vapor produced by your coil will gradually lessen with time.

How do you fix a vape that won't smoke?

Check your tank to make sure you have enough e-liquid. If your tank is completely full but you still have weak vapor, it is possible that your atomizer or coil has been flooded. If this happens, simply take your atomizer apart and clean it with a paper towel or gently blow through it to get the excess liquid out.

How do you clean an atomizer?

To carry out this method, simply submerge your atomizer in some isopropyl alcohol for 30-60 minutes. This will cause the hardened dirt to become saturated and it will break down and pull away from the atomizer when you wipe it down with your cotton buds.

Why do atomizers stop working?

“Check Atomizer” or “No Atomizer” will appear when your vape mod or pod vape isn't reading your coil correctly. This can be due to the 510 connector not reading properly (where the tank screws onto the mod), the coil not making proper contact inside of the tank, or possibly a short.

Is an atomizer a coil?

The coil is a small part in an electronic cigarette which gets hot. A coil head is also known as an atomizer head. These are words for the same thing, the heating element inside an e-cigarette.

What is atomizer on a vape?

Atomizer refers to the wick and coil within a vape device. The wick (typically made of cotton) draws in e-liquid from the tank and onto the coil - the element that heats the e-liquid to produce a vapour.

How long do vape atomizers last?

Most wax atomizers will need to be replaced within 4 to 12 weeks. This number depends on how often you vape, and the temperature you choose. Those who vape constantly at high temperatures will need to replace their atomizer more frequently.

How long do atomizer coils last?

between one to two weeksA new coil should last between one to two weeks. However, most e-liquids leave a thin layer of residue when they are vaporized. This builds up around your coils and wicks and can end up clogging your device in the long run.

When should I replace my vape atomizer?

However, there are several signs which indicate that it's time to replace your coils.Burnt Taste. The first and most prominent way to tell your coil needs changing is by experiencing an unpleasant burning taste in your vape.Bubbling Noise. ... Weak Flavour. ... Little Vapour. ... Leaking Device.

What is an atomizer in vaping?

Posted by Evelyn on August 8, 2019. Atomizers are the heart of vaping. Vape pens and mods are the power supply unit and the atomizers are responsible for vaporizing e-liquid. The term atomizer can refer to different things. It can refer to devices containing coils or it's also used to refer to the coil inside the device.

How to fix an atomizer short?

How to fix an "Atomizer short" warning: Place batteries on an external charger to ensure they're both charging properly. For rebuildable atomizer users (RDA/RTA), make sure the coil is not touching the cap or deck and contains no breaks in your coil.

Why is my mod coil seated loose?

If the resistance of the coil is compatible with your mod then it could be that the coil is seated loosely, defective coil, or a faulty 510 connection. So always make sure your coil is seated and screwed in tight and if it's a bad coil then replace it.

What is a RTA atomizer?

It can refer to devices containing coils or it's also used to refer to the coil inside the device. There are three types of atomizer devices: vape tanks , rebuildable drip atomizers (RDA), and rebuildable tank atomizers (RTA). These devices all use a coil that heats up and transforms vape juice into vapor.

Why does my atomizer give me a short message?

There could be a number of reasons why your device is giving you a short message. If you are using a rebuildable atomizer then your coil could be touching an unintended area like the deck or cap of the casing. If you are using a tank with a pre-built coil then the coil can either be defective or it could be loose.

How to tell if coil is bad on vape?

If you are using a vape tank with pre-built coils then check to make sure that the coil's base is connecting to your tank base. Pull the base of the coil out slight then reassemble the tank and make sure the coil is on tight. If the coil is on tightly and still reading atomizer short then you might have a bad coil. Sometimes there could be one or two bad/defective coils so try using a new coil from the pack to see if that is the issue.

Why does my atomizer say no atomizer?

This typically happens because the coil isn't screwed on properly, there's an issue with the 510 connection, defective or bad coil, etc.

Why do vapers forget atomizer error messages?

They were added by the manufacturer to protect you from faulty atomizers, and to prevent firing mishaps that can cause damage or injury.

Why is my atomizer short?

When your chipset is responsible for an “atomizer short “or a “no atomizer” error message, it means that it’s preventing firing on the basest of levels. There’s nothing here that you can fiddle with or adjust to fix this. Your heating chamber and atomizer head are simply not getting the juice they need because that little computer is not telling your e-cigarette to send it there. A good idea would be to reach out to the manufacturer (or the dealer) to try to get a replacement device. Just keep in mind that some companies are better at customer service than others – often, if the manufacturer is stalling you, it’s best to cut your losses and buy another mod. Of course, before purchasing any of these high-end mods, do your research and check online to read what other vapers are saying about them.

How to check rebuildable coils?

For rebuildable coils, check the coil and the connection and make sure that everything is tightly screwed so it’s not wobbling when you put the top cap on. Also, check the size of your coil – if it’s too big and touches the sides, you will keep getting an atomizer error message. Build a slightly smaller coil that can fit neatly on your build deck and you should be fine.

Why does my vape pen show error messages?

When juice seeps into your circuitry, the connector, and the contact points, and it can damage them and cause your vape pen to show error messages when there’s actually nothing wrong with the atom izer.

Why does my vape pen leak?

There’s vape juice in your vape pen – leaky atomizers are damaged atomizers. When juice seeps into your circuitry, it can damage it and cause it to show error messages when there’s actually nothing wrong with the atomizer.

Why are vapes added to vapes?

They were added by the manufacturer to protect you from faulty atomizers, and to prevent firing mishaps that can cause damage or injury.

What does it mean when your chipset says no atomizer?

When your chipset is responsible for an “atomizer short “or a “no atomizer” error message, it means that it’s preventing firing on the basest of levels. There’s nothing here that you can fiddle with or adjust to fix this.

Why is my sub ohm tank not tight enough?

If you are using a sub-ohm tank, then it is possible that your coil was inserted incorrectly, or it was just not tight enough. So simply re-insert it. Sometimes it’s just as simple as that!

What to do if you are using a rebuildable tank?

If you are using a rebuildable tank, make sure your build is not touching the cap or any other metal piece of the deck. Also make sure your coil is in good shape and there are no breaks.

What does "check atomizer" mean?

One company may use the standard “atomizer short” error for a shorted coil, while another may say “check atomizer” for the same reason—or use it as an umbrella term for all atomizer issues.

Why do atomizers use peek insulators?

Almost all atomizers these days use PEEK insulators to separate the positive from the negative. Any damage to your insulators may cause a short, resulting in an “atomizer short” or a similar error.

Why is my mod not working?

Six reasons for your mod errors (and how to solve them) 1. Coils may have a short. It could be something as simple as a bad factory coil, a loose connection on your rebuildable , or the factory coil itself isn’t properly seated or missing an insulator. Also, some people may misjudge the size of their builds, causing their coil to touch ...

What is Vaping360?

The Vaping360 team is a diverse group of experienced vaping contributors. We strive to bring you the finest content on all things vaping. Don’t forget to follow us on Facebook and Instagram for more!

What to do if your coil doesn't work?

If it still doesn’t work, try another coil. If the new coil works, you just got a bum coil which happens from time to time. For rebuildables, make sure to check your coils and all the connections are tight. The screws on a post may loosen a bit after during the build process—they may also loosen gradually with time.

Can you use a different atomizer with a mod?

Remedy: While there is nothing you can do yourself—unless you are familiar enough to replace or modify a 510 pin on a mod—sometimes using a different atomizer could work. Atomizers have different lengths on their 510 pins and some mods may just not work well with a shorter or longer one. While it’s somewhat rare these days, it is possible for an atomizer to not be compatible with a mod due to its 510 pin. If some atomizers work and others don’t, it’s likely a poorly designed 510 connection on the mod.

Does dry burning a coil raise resistance?

Remedy: If you are using a rebuildable, note that dry burning the coil may eventually raise its resistance. If you are set on vaping on that coil, you will need to find a mod or an ohm meter that will fire it and see if dry burning it puts it into the range that your mod operates at.