screw off the battery cap, put one high-rate 18650 battery (positive side down and negative side up) into iStick Pico 25 and finally screw the battery cap on. The device can be powered on/off by pressing the fire button 5 times. Note: 1.Please be careful not to use battery with torn casing as it is a safety hazard.
Full Answer
How do I set up my istick Pico atomizer?
iStick Pico - Atomizer Setup 1 Step One. Gather your iStick Pico, Atomizer and 18650 Battery. ... 2 Step Two. Screw off the battery cap, put one high-drain 18650 Battery into the iStick Pico with the positive end facing down, then screw the battery cap back on. 3 Step Three. ... 4 Step Four. ... 5 Temperature Control. ...
How do I replace the battery in my istick Pico 25?
screw off the battery cap, put one high-rate 18650 battery (positive side down and negative side up) into iStick Pico 25 and finally screw the battery cap on. The device can be powered on/off by pressing the fire button 5 times.
What modes does the istick Pico support?
The iStick Pico is a 75w maximum output device powered by a single 18650 Battery and supports the following modes: Variable Wattage, Bypass, TC-Ni, TC-Ti, TC-SS and TCR. Depending on your Atomizer and Coil, you will be using the Variable Wattage, TC-Ni, or TC-SS modes only. Please make sure you are using a proper high-drain 18650 cell.
What is the wattage of eleaf istick Pico?
The Eleaf iStick Pico is a box mod with 510 threading and a wattage range from 1 to 75W for compatibility with nearly every 510 attachment. It has temperature control modes for nichrome, titanium and stainless steel heating elements with a range of 200-600 degrees Fahrenheit.
How do I setup my iStick Pico?
Simply remove the battery cap and pop your new battery into the iStick Pico with the positive (less exposed) terminal facing down into the device, and the negative end (more exposed) pointing out towards you! Screw on the battery cap and now you can power on the device by pressing the fire button 5 times.
How do you unlock an iStick Pico vape?
0:281:33How to Lock and Unlock an Eleaf iStick Pico 75w - YouTubeYouTubeStart of suggested clipEnd of suggested clipHold him for a couple seconds boom unlocked and now there's no ID on there you know I can adjust theMoreHold him for a couple seconds boom unlocked and now there's no ID on there you know I can adjust the power. So again to lock it if you do want to lock it.
How do I use my iStick vape?
2:026:41Eleaf iStick - HOW TO and Review - YouTubeYouTubeStart of suggested clipEnd of suggested clipSo as you push the button. Up or down it'll move the voltage up and down to change the voltage. DownMoreSo as you push the button. Up or down it'll move the voltage up and down to change the voltage. Down. Quickly you can hold the button down and click it twice.
What coil does the iStick Pico use?
Like its bigger brothers in the Melo line, however, it uses a full-sized factory coil head. Two heads are included in the Kit, both vertical Kanthal coils, in 0.3 ohm and 0.5 ohm resistances.
How do I reset my Eleaf iStick power?
The iStick Power can be reset by keeping holding the up button and reset button simultaneously in case it could not be powered on after upgraded.
How do I lock my Eleaf Ipower?
In Stealth On mode, you can vape with the OLED screen off and you can press the fire button one time to see current setting. when the device is powered on, then the up and down buttons will be locked and the screen will display “Lock”.
Why is vape blocked?
The most common cause of a clogged cart is condensation buildup inside the cart's airway. Over time, this condensation can block the mouthpiece, preventing vapor from passing through as you take a hit. Instead of a tasty hit of delta 8 THC, you get a clogged mouthpiece and a mouth full of bitter vape juice.
What is Eleaf iStick Pico?
The iStick Pico, just like its name, is preferable, innovative, compact and outstanding (PICO). Powered by single interchangeable 18650 cell, it provides you with 75W maximum output and switchable VW/Bypass/TC-Ni/TC-Ti/TC-SS/TCR modes.
How do I open my vape tank?
Rubber gloves: Put on a pair of washing up gloves and try to unscrew the tank with them on. They increase grip and make it much easier. Rubber bands: Wrap a rubber band around the metal part of the tank. The increased grip will make it easier to unscrew in your hands.
How do you clean a burnt coil?
How to clean your CoilLet your coil soak in ethanol, vinegar, or cheap vodka for at least a couple of hours.Place it under the tap and rinse.Rinse once more with some distilled water.Blow air on the open side of your coil to force water to the wicking holes.Set it aside until all water has evaporated.
Is Eleaf Pico good?
The Eleaf iStick Pico mod is smaller than I expected, considering it is powered by a replaceable 18650 battery. It fits perfectly in my hand, which has to be said aren't the biggest. The rounded edges of the mod make it comfortable to hold even for prolonged periods. The build quality is excellent, it feels very solid.
What is the best wattage for a 0.3 Ohm coil?
The sweet spot for getting a balance of vapour and flavour is around 0.3ohms. Depending on your coil choice you'll want to up the wattage from anywhere between 50 and 100 watts.
How to set iStick to 10.0W?
First, put your iStick into Wattage mode by pressing the Fire button 3 times in quick succession, the iStick will show the current mode. Press the Up or Down button until Wattage is displayed, then press the Fire button. Now use the Down button to set the wattage to around 10.0w.
What cell is used for a TC-Ni atomizer?
Please make sure you are using a proper high-drain 18650 cell. If you received your battery directly from MaxVapor, you received a Sony VTC5 or equivalent.
How to lock resistance on a Fire tablet?
To Lock / Unlock resistance, press and hold the Fire button and Up button simultaneously for two seconds. The Lock or Ohm sign will appear depending on the current setting.
How big is the iStick Pico 25?
The iStick Pico 25 ingeniously packs a big 0.91-inch screen that offers a concise and clear interface, 2A quick charge capability and upgradeable firmware with preheat function in a compact, stylish yet powerful package. Powered by single 18650 battery, the iStick Pico 25 is capable of outputting a maximum power of 85W and can handle various tanks up to 25mm diameter. The ELLO atomizer that features the HW coil for ultimate flavor and retractable top for easy filling pairs with the iStick Pico 25 perfectly in terms of both appearance and performance.
How to adjust temperature on TC-Ni?
in TC-Ni/TC-Ti/TC-SS/TCR (M1,M2,M3) mode, temperature can be adjusted from 100-315℃ or 220-600℉ by pressing “+” or “-” button, “+” button to increase and “-” button to decrease. Each press of the “+” or “-” button will increase or decrease the temperature setting by 5℃ or 10℉. Keep pressing “+” or “-” button without looseness can rapidly increase or decrease temperature setting.
How to change TCR on a spherical coil?
1. Press the fire button repeatedly to choose among M1, M2 and M3 modes; 2. Press the “+” or “-” button to increase or decrease the TCR value according to the material of the coil you use; 3. Keep pressing the fire button or stay in the interface for about 10 seconds to confirm your setting.
How to switch between stealth and stealth off?
press the fire button and “-” button simultaneously when the device is powered on to switch between Stealth On and Stealth Off mode. In Stealth On mode, you can vape with the OLED screen off and you can press the fire button once to see current setting.
What happens if your vape is too hot?
if the temperature of device is over alert temperature, the output will shut off automatically and the screen will display “De vice Too Hot”. You can continue to vape after it cools down
How to charge 18650 battery?
The 18650 battery can be charged in the device through USB port via wall adapter or a computer or charged with an external battery charger. If the 18650 battery is charged in the device, the battery bar on the screen will keep flashing during charging and the screen will go out when fully charged.
iStick Pico Best Settings
When it comes to vape, the best settings would be different for each person. So, it is impossible to share a setting that would be the best for everybody. As a result, in this section, we will tell you how you can get the best out of the iStick Pico.
Wrap Up
The iStick Pico might be an old device by now. However, a lot of people still use it. In this post, we have shared a few adjustments for the iStick Pico kit. You can try each of those, one by one. We hope you will find a setting that is the most suitable for you.