Filling a Bottom-Fill Vaporizer
- Remove the coil from the bottom. Unscrew the bottom metal piece of the vaporizer and set it aside. ... Clean out...
- Put a drop of e-liquid into the coil and attach the coil to the vaporizer. ...
- Fill the tank with e-liquid. Unscrew the entire metal bottom of the vaporizer to get access to the tank.
How do you fill a top-fill vape?
If you need to fill your top-fill vape, start by unscrewing the airflow base at the bottom of the vaporizer and pulling out the coil. Next, prep the coil by dropping 1 drop of e-liquid onto each cotton hole located on the coil.
How to fill a vape pen with liquid?
The most important part of filling a vape pen with liquid is going to be to make sure that you are keeping good track of the liquid itself and not letting it spill everywhere. So, you will probably need to remain stationary to avoid dropping oil all over yourself, your vape pen, and the area around you.
Should you stir your vape pen between sessions?
Both require proper heating chamber packing, however, a combustion vape pen might need to be stirred in between vape sessions given that it is igniting the dry herb from the bottom up via a hot coil – versus combustion vapes that heat like an over. For one thing, there will likely be extra things you can do that will depend on your vape pen.
What do you need to know about vape coils?
One of the first things you need to understand is your coil. For example, if you’re using an older vape or a model based on older tech, you might have a wick coil. A wick coil uses a fabric wick, usually cotton, to heat up your wax. This works better with more liquid waxes and not thicker, stickier waxes (although it can still operate).
How do you fill a vapor cigarette?
Top fill vape tankScrew off the top of your tank (Twist or slide top depending on the tank)Find the e-liquid fill hole.Place the tip of the e-liquid bottle into the fill hole.Slightly tilt the vape tank at an angle to stop air pockets.Slowly squeeze the bottle and fill the tank.Leave an air bubble at the top.More items...
How do you refill an e-cig cartridge?
Steps: Refill E-Cig CartridgeFirst, make sure that you disconnect the refillable cartridge from the battery. ... Next, remove the cap from the needle-nosed e-liquid bottle. ... Insert the tip of the bottle into the top of the cartridge (the same side as the mouthpiece). ... Last, reattach the cartridge to the battery.
How many times can you refill a vape cartridge?
It entirely depends on how a user takes care of the device. However, it can be refilled between two to seven times. You have to take care of the device and refill it between these numbers. It can go below or above the given number, but it will start giving an unpleasant experience after a certain point.
How do I open my vape tank?
How to Refill a Vape TankTo refill your top-fill tank, start by removing it from the body of your e-cig mod.Unscrew the base and carefully remove the coil. ... Next, unscrew the top of the tank to add your e-liquid. ... Reassemble your tank and screw all the pieces back together tightly.More items...•
Bottom fill vape tank vs top fill vape tank
Before we start a step-by-step guide, we should mention that there are two types of vape tanks, and their design has a pretty significant influence on the method we will use to refill the e-liquid. Of course, we’re talking about top fill vape tanks and bottom fill vape tanks.
Filling bottom fill vape tank
If your device fills from the bottom, you should check whether you need to completely empty the tank or if it’s possible to add e-liquid while some of it is still in the chamber. Of course, it’s always best to finish your current vape juice and give a tank a quick clean.
Filling top fill vape tank
This type of filling system is unquestionably the most popular one, and it’s no surprise as it’s quick and easy to work. It’s worth mentioning that top fill vape tanks may come in slightly different forms – they can have a screw-off top, twist off, or a sliding lid.
Cleaning the tank
It doesn’t matter if your vape tank is filled from top or bottom – it still needs to be cleaned from time to time. This habit will put a stop to a build-up of e-liquids in the chamber, so be sure to do it regularly. The moment when you’re about to refill your tank is the best one as the device is already empty.
What about a closed pod system?
We should also mention that there are tanks that weren’t even designed to be refilled! We’re talking about closed pod systems. These devices already come filled with vape juices, and when you finish it off, you should simply throw out the used pod and replace it with a new one.
How to Fill a Vape Pen 101
Ultimately, vape pens can cover a wide array of options. It can range from dry herb vaporizers to wax pens, to various other models. Due to such a vast assortment of devices, the exact process for filling up a vape pen can change from one model to the next. Generally, it comes down to not only the model but also what type of material it is used.
How to Fill a Vape Pen with Liquids
Whether you prefer e-juice, oil, a nicotine-based option, or some other liquid substance, vape pens are very versatile in the type of liquids you can use to vape. However, no matter what the liquid substance, the process for filling a vape pen with liquid remains the same.
How to Fill a Vape Pen with Wax
Wax pens are a fairly easy device to use. To begin, you simply turn on the device by clicking the power button 5 times in quick succession. Once it is on, a light will flash. Users can load the device fairly easily by opening up the mouthpiece by unscrewing it. Using a dab tool you can load the wax concentrate onto the exposed coil.
How to Fill a Vape Pen with Dry Herbs
The biggest difference between dry herb vapes and liquid or wax vapes all comes down to the loading process. Unlike liquid and wax, dry herbs need to be ground up before you fill up your vape pen. Once the herbs are ground up, place them directly into the chamber by removing the cap or cover exposing the chamber.
Tips for Filling a Vape Pen Carefully
In order to fill a vape pen carefully, there are a few key points you will want to keep in mind:
How to Re-Fill a Vape Pen
When re-filling a vape pen, you fill it exactly the same way as you did the first time. Nonetheless, there are things to keep in mind you do not need to worry about during the first time you fill your vape pen.
Can you put Water in a Vape Pen?
Vape pens are an electronic device. Therefore, the parts they use are designed for the specific concentrate they vape (liquid, oil, wax, etc.). Unless a vape pen explicitly is meant to use water, you cannot put water in a vape pen without damaging or even ruining the device.
Step 5
Wait for 2-3 minutes, to allow the coil to become saturated with e liquid. After that, your tank is ready for use.
Step 1
Unscrew the bottom connector from your tank, and remove the vape coil by gently pulling it out.
Step 2
Drip a few drops of e liquid onto the coil. Gently dousing the coil in e liquid helps extend its lifespan. Then, re-insert the coil back into the tank.
Step 3
Unscrew the metal bottom connector to gain access to the tank chamber.
Step 5
Leave the coil to saturate for a few minutes. After that, your tank is ready for use.
Guides & Help with Tanks and Coils
As you can see, refilling your tank is nothing to worry about. As such a key part of everyday vaping, this process has been expertly designed to be as smooth and simple as possible.
How to fill a vape tank?
Here’s how to fill an e-cig or vape: 1 Unscrew the dripper (some tanks can be filled from both top and bottom, this choice is up to you) 2 Fill the tank with your chosen e-liquid 3 Avoid getting any e-liquid in the chimney (as this can then result in ‘gurgling’ as it enters the airway where you’ll be drawing your vapour from.) 4 Not sure which is the chimney? If you look at the tank you’ll see in the middle is the chimney and this is connected to the coil. 5 The e liquid should sit around the outside of the chimney so it can soak into the cotton that encases the coil and produce that nice vapour flavour.
Where does the e liquid sit in a vape tank?
If you look at the tank you’ll see in the middle is the chimney and this is connected to the coil. The e liquid should sit around the outside of the chimney so it can soak into the cotton that encases the coil and produce that nice vapour flavour.
How high can a vape tank leak?
Are you planning to enjoy a drive in the mountains? If you are, you should know that vape tanks are highly prone to leaking during ascents of more than around 2,000 feet. That’s because the changing air pressure pushes the e-liquid through the coil and out the bottom of the tank. If you’re going out for a high-altitude drive, fill your tank halfway to mitigate leaking during your ascent. Alternatively, just hold off on filling your tank until you reach the highest-altitude point of your trip. Your tank won’t leak on the way down; it’ll only leak on the way up.
How to open a tank on a mod?
Twist the tank’s bottom hardware counterclockwise until it comes off. In most cases, the atomizer coil remains connected to the tank’s bottom hardware and comes out of the tank as well. Set the tank’s bottom half aside and continue holding the top half. Grab your bottle of e-liquid.
How to open a vape tank?
If you don’t have the manual, then the next best option is to look for a marker somewhere near the top of the tank. You can usually open a vape tank in one of three ways.
Why do vape tanks open from the top?
Most vape tanks today open from the top because that’s what most vapers prefer. If you have a tank that opens from the bottom, you have to remove it from your device before you can fill it. A tank that opens from the top is both more convenient and less messy, so that’s how most tanks work these days.
Can you use a new coil without priming it?
Most modern vape tanks are pretty forgiving if you happen to make a small mistake during a refill. The one thing you shouldn’t do , though, is use a new coil without priming it first. When you prime a new coil, you get the cotton wick completely wet with e-liquid before you begin using it. That’s an important step because you could burn the cotton if you vape with a coil that isn’t completely wet. A coil with a burned wick will always produce a burned flavor; there’s no fix for that. So, in this case, it’s extremely important that you do things right the first time.
How to use a dabber for vaping?
Use a dabber to load the wax coils but NEVER poke the coils directly and try to avoid contact at all costs. Just gently push the ball of wax towards the coil and the heat should do the rest while you are vaping. In addition, you will want to make sure you don’t overpack your wax pen.
What is a vape pen?
First things first, the term ‘vape pen’ is a bit generic. There are all kinds of vape pens. Some vape pens such as a dry herb vaporizer, wax pen, and oil pens (pre-filled and reusable, empty ones) and this will all affect how you fill your vape pen. Not to mention, not all vape pens have the same styles or features, ...
Why is a glass globe vape pen more sensitive to damage?
For example, a glass globe vape pen might be more sensitive to damage because of the, well glass globe that can shatter if bumped the wrong way.
Why do you need to be stationary when filling a vape pen?
The most important part of filling a vape pen with liquid is going to be to make sure that you are keeping good track of the liquid itself and not letting it spill everywhere. So, you will probably need to remain stationary to avoid dropping oil all over yourself, your vape pen, and the area around you.
Why do you need to avoid overpacking a heating chamber?
Another thing to keep in mind is that you’re going to want to avoid overpacking the heating chamber because the hot air in the chamber needs space to flow and heat all of the herbs.
Which is better, quartz or ceramic coil?
Be very careful about underfilling and leaving too much exposed, dry wick. This will cause it to burn and affect your taste and performance. A quartz or ceramic coil will work better with thicker, stickier waxes.
Can you refill a vape pen?
One thing to keep in mind with refilling your vape pen is that you will pretty much do the same thing you did the first time around. However, when reopening the heating chamber and going to refill it, you want to be careful that any residual wax, oil, or dry herb/ash are not going to fall or leak out.
How to take a vaporizer apart?
The first step is to take your vaporizer apart precisely, while remembering what goes where for later. Unscrew the mouthpiece and the airflow base at the bottom of your device to reveal the coil.
How long should I let my e-liquid settle?
Step 5: Let your e-liquid settle. When everything’s back in place, it’s always best to allow your e-liquid to ‘steep’ inside your tank for 5 minutes. Your coil will then be primed to deliver a supreme vaping experience with optimum flavour.
