Can e-juice leak into your mouth while vaping?
However, e-juice leaking into your mouth while vaping is the other side of the spectrum which brings a totally different set of concerns to the table. Striking a balance between these two extremes will not only enhance your smoking experience from a sensory perspective, but it also takes a few unnecessary health risks out of play.
Does e-juice taste good when vaped?
And the unfortunate thing here is that E-juice tastes great when vaped – not so much when you have a mouthful. What’s Going On Here? While finding E-juice in your mouth during vaping may or may not be objectionable to everyone, it is so very common that it even has a name.
Can you have too much vape juice flavor?
From chocolate cake to raspberry lemonade, there are a host of exciting vape flavors to enjoy that taste great as vapor and smell fantastic. However, if you’ve ever had the displeasure of tasting leaked vape juice within your hits, then the high flavor concentration serves as a quick reminder that it’s possible to have too much of a good thing.
Why does my e-juice shoot into my mouth?
Reason #2: You’re attempting to inhale vapor too quickly. You want your vapor to hit your lips as quickly as possible when you vape. So you fill up your tank with e-juice, reassemble your e-cigarette, and then start taking a big, long drag right away. And then…bleck! E-juice shoots into your mouth and you cringe.
Reason #1 – A Dead Coil
- Your coil may be done dancing if it is giving you a lot of spit back. They only last so long, after all, even under the best circumstances. Don’t expect that coil to last a month or two. A week or two is about as long as you should use a coil for. The kind of E-fluid that you use can have an effect on …
Reason #2 – Bad E-Fluid
- “Bad” may not be the right word. It could just be that you’re using the wrong kind of E-fluid. Your tank’s or device’s performance depends largely on what kind of E-liquid you use in it. You might be asking for trouble if you have a sub ohm coil and you are using an E-fluid that is high in PG. They tend to be watery and thin. They flow right through your coil. On the other hand, E-fluids with hig…
Reason #3 – Did You Over Prime The Coil?
- This is a common mistake and happens frequently; particularly if you’re not familiar with a tank or device. Correct coil priming is executed by applying a bit of E-liquid to the wicking ports. Just drip, down the center of it, a few drops. Some will require less juice, some more. You don’t want build-up in the chimney, you just want to saturate the cotton well. The solution – if you do happen to o…