Three Reasons Why Your Coils Burn Out
- Chain vaping - Taking multiple draws over a few seconds will dry out the wick faster than it can soak up e-juice.
- Breaking in coils - New coils that are heated too high can pop or break.
- E-liquid selection - E-juice high in sugar caramelizes the coil leading to a gunk buildup
Full Answer
Why does my vape Wick dry up so fast?
Vaping at wattages that exceed the coil limits will vaporize e-liquid too fast. When that happens, the coils can burn the wicks, even when there’s still some juice there. Always stay inside the recommended wattage ranges. When taking many puffs in a row, the wick will dry up fast.
Why do vape coils burn out?
The final reason a coil can burn out applies to MODs, portable vaporizers, and e-cigarettes alike, as it has to do with the vape juice you choose to use. E-liquids range in sugar content and VG/PG ratio. High sugar content e-liquids can present a problem when it comes to long vaping sessions.
Why do my new coils taste burnt?
The most common reason why a new coil taste burnt is because it was not primed for enough time. Remember to prime the coil for at least 10 minutes and avoid high power vaping for the first puff. After it is primed and ready, set up your device at a low wattage range.
Why does my coil burn so fast in my vape?
Sub-ohm coils heat up much quicker than those with a higher resistance. If your e-liquid has a thinner consistency then the atomizer head can vaporize it too quickly, causing premature burning.
How can I make my vape coil burn less?
Priming your coils is the best way to avoid dry hits. By soaking your coils with a small amount of your e-liquid, your wick will soak up the fluid to prevent it from burning. Last but not least, put the coils back in your e-cigarette and vape as normal.
Why is my coil burning after 1 day?
Ensure Your Tank Is Properly Filled While this might seem obvious, the first port of call when your coil is burning is to ensure that it is properly saturated with e-liquid. Allowing your tank to run on empty while still vaping will inevitably cause dry burn, which can permanently damage the coil.
Why does my coil taste burnt after 2 days?
It tastes burnt because the wick inside your atomizer coil has dried out and burned up when it was heated. The wick is the part of your vaporizer that soaks up the eliquid from the tank. The wick holds onto this eliquid before it is turned into vapor when the coil heats up.
Why does my vape coil burn out?
6 Common Reasons Why Vape Coils Burn Out – and How to Avoid It! 1. Not Enough Vape Juice in the Tank. Whenever your wick is dry, it will not function properly. As mentioned, the wick needs to be saturated in vape juice. In case you vape frequently, then your tank will start to run empty and the wick will not soak up as much ...
How to avoid burnt coils in vape?
To avoid the burnt coil, keep checking your tank and top it up when it is at a third of its capacity. 2. Chain Vaping.
What happens when you vape with a wick?
This wick surrounds the element which usually heats up the moment current passes through it, causing the vape juice to evaporate. Once evaporation occurs, the vaper can inhale the vapor that’s produced. However, if the wick wasn’t primed properly before you took your first puff, you’ll experience a burnt taste.
What happens if you use a coil that isn't high grade?
If you do so with a coil that isn’t high-grade, the wick won’t be able to handle the heat these wattages will generate and will end up burning. The solution to this is to simply reduce your power setting and find out the ideal wattage you should vape at.
What happens when you vape multiple puffs?
This causes the wick to burn.
Why is it important to take care of your coil?
While preventing your from burning out seems like a lot of work, it’s worth it because it helps you avoid losses. It also saves you the trouble of experiencing an irritating burnt taste. Taking care of your coil could mean the difference between an enjoyable vaping experience or a terrible one.
Can you use a lot of sweetener in vape juice?
Using a Vape Juice with a Lot of Sweeteners. Vape juices that contain a lot of sweeteners can cause gunking up of coils. While they may be delicious, they could significantly destroy your coils. When gunking happens, the wick will be unable to soak up more juice so when you vape, the coil could get burnt.
Why priming a coil is so important
Priming the coil is the first line of defense for this problem. Each time you buy a new tank or replace atomizer heads, carefully place a couple of drops of e-liquid inside the coil. You can also drip e-juice directly through those holes surrounding the coil.
E-liquid thickness plays a crucial role
Next thing you need to watch out for is the viscosity of your liquid. Depending on the type of tank and coil, it may not be able to handle high VG juices. If the coils and wicking holes are tiny, then chances are you can use a maximum VG mix of 70%. From our experience usually 60/40 e-liquids are best suited for all types of clearomizers and tanks.
Why your coils keep burning out
When your coils get constantly burnt despite priming them and using lower wattages you now you have an e-juice problem. Carefully check out the label or on-line specs and try a brand with a lower VG content. DIY e-liquid is also a great alternative and it gives way more control over the desired thickness.
Can sweeteners shorten the life of a vape coil?
While added sweeteners can do wonders for replicating the flavour of our favourite fruits and baked goods, they do noticeably shorten the life of your coil, especially in larger quantities. As you vape, the sweetener in the e-liquid may leave residue on the coil.
Do coils last longer?
However, there are some ways to avoid dry hits for good and make your co ils last longer.
Why does my coil taste burnt?
Given that we know that burnt coils can produce harmful chemicals , you should probably still change it. Occasionally, you’ll also get a burnt taste when you have just replaced a burnt out coil.
How to stop coils from burning?
The best ways to stop your coil from burning are: 1 Prime your coils 2 Stop chain vaping 3 Reduce power settings 4 Keep your vape tank topped up 5 Use an e-liquid with more PG 6 Try an e-liquid with less sweetener 7 Use temperature control 8 Use smart mode 9 Use auto-priming technology
Why is my coil head not soaking up?
On many coil heads, the juice has to be at a certain level to even reach the wicking ports. When less of the juice is in contact with the wick, it doesn’t get soaked up as quickly. When your juice level is really low, this can cause problems very easily. The simplest solution to this is to keep your tank topped up.
How does a fire button work?
When you hit the fire button, electricity flows through your coil and it gets hot. The heat given off by the coil is taken up by the e-juice, which is soaked into the wick, and it turns the juice into vapour.
What is TC vaping?
Temperature control (TC) vaping solves the problems with burning wicks more directly. By tracking the detectable changes in resistance that occur when certain coil materials are heated up, TC devices such as the Geekvape Aegis Max Zeus allow you to set a maximum temperature for your coil.
What happens when you vaporize a wick?
When the juice in the wick has been vaporised, the wick dries out a little. However, you have a tank full of e-juice surrounding the coil, and this is constantly replacing the juice in the wick. This means that by the time you go to take another puff, the wick is soaked again and everything works as it should.
How long after filling up a vape tank should I wait?
Now your new coil is ready to go. But, as an extra precaution, it’s still better to wait about five minutes after you fill up your tank before you start vaping.
Why does my atomizer burn?
Burnt hits are the result of powering an atomizer when there is no liquid or not enough on the wicks. Without liquid to vaporize, the coils start burning the wick, and the user essentially inhales burnt cotton. Here are some of the most common reasons behind burnt hits and some advice to help you avoid them.
Why does my e-liquid burn?
Here are some of the most common reasons behind burnt hits and some advice to help you avoid them. High wattages. Vaping at wattages that exceed the coil limits will vaporize e-liquid too fast. When that happens, the coils can burn the wicks, even when there’s still some juice there.
How long does a coil last?
Consumption. A coil is generally good for up to a certain amount of e-juice. The more you use it, the faster it dies. Coil life is sometimes calculated in days or weeks, but the most accurate way to calculate it is in mL—some people vape only a couple of mL per day, while others will consume 10-20 mL or more.
How to know when your coil is done?
Knowing when your coil is done is not a science, but it is a learning process. The more you use a vape tank, the more aware you become of the time you need to grab a new coil out of the box. The first sign will usually be a loss of flavor, followed by a drop in vapor production.
How to start vaping on a pod?
When you first begin vaping on a pod, try and take shorter puffs to begin with. Some of the smaller coils need to be broken in a bit before being pushed. If you take really long hits to start, even if the wick is fully saturated, you could get a burnt hit.
How to prime a vape tank?
How to prime vape tank coils. All vape tanks that come with replaceable coil heads have more or less the same structure and require the same simple steps to get primed. You will need to repeat this process every time you replace a coil. Take a new coil out of the box.
How to keep vape wick from drying up?
Always stay inside the recommended wattage ranges. Chain vaping. When taking many puffs in a row, the wick will dry up fast. If you sense that a burnt hit is coming, by noticing a slightly roasted taste, put your vape down for a moment. This will allow liquid to cover the dry spots of the wick.
Marcel K Senior Member ECF Veteran
Ok thank you, I will try to buy direct from the maker and see if that helps.
Topwater Elvis Vaping Master ECF Veteran
The u force tank on top of your mojo is designed for a DTL inhale style ( hard, strong, fast, deep, direct to lung inhale method).
Topwater Elvis Vaping Master ECF Veteran
After priming/thoroughly saturating all exposed wicking material on a new/unused head, best to start low, take 3 -4 vapes, turn it up 2w - 4w take a few vapes, continue to gradually raise over about the first half tank or stop raising the power when you find what you like in vape quality.
Letitia Citrus Junkie ECF Veteran
Thanks so much for the info, no one ever told me to start low and build up with each coil, I have been starting them out at the 48w that I usually go with. So how often should I raise the watts after putting the new one in, should I do a few hits every time I change the wattage before upping it again.
Tonee N Vaping Master Verified Member ECF Veteran
What the company marks the coil as "Best At" is not necessarily what it is going to be best at for you. I have used coils with the 40-80 suggestion and finally discovered that they work best in a device that has Variable Power Control or a Curve option where you can ramp the wattage slowly or preheat the coil.
Topwater Elvis Vaping Master ECF Veteran
Vaping does have a learning curve, at first it is quite a bit more 'work' than lighting a smoke.
Letitia Citrus Junkie ECF Veteran
Thanks for all the great info. Any suggestions on juices companies I can buy a 30pg/70vg juice from. I am going to try what you said and see how that works. Hopefully I will get this right soon because that nasty burnt taste in my mouth is disgusting. I am beginning to think I might be doing it to much.