Meanwhile, a vape pen blinking red often means you have a low battery, and the pen will switch to low mode power output, especially when the vape pen blinks while you are taking a drag. The pen will turn off once the battery capacity reaches about 3.3V. This automatic shutdown is called low voltage protection.
Why does my innokin vaporizer say “innokin not working”?
If you’ve got even a small amount of experience with vaping, you’ll likely have encountered this error before in some shape or form. This error message is most commonly encountered when there is a communication issue between the coil and battery of your Innokin vaporizer setup.
Why is my vape pen blinking red?
The coil is short-circuited. The resistance value of the coil is too small. Why is my vape pen blinking RED? When you are charging, it indicates under charging.
What does the LED light behind my vape’s fire button mean?
You may want to know that the LED light behind your vape’s fire button is used by most manufacturers to give you any warnings or signals that could interfere with your vaping experience, especially if the device doesn’t have a digital display.
Why is my vape flashing and not smoking?
The more common of these is the connection between the battery mod and the tank: the 510 pin. If the 510 pin has dropped or become stuck in the ‘On’ position, your vape won’t fire and will most likely give you a flashing light. If the staff at your local vape shop don’t do repairs, it might be time for a new mod.
Why is my innokin vape not working?
If you try to vape and are stopped by a flashing button, this typically means the short-circuit protection feature has kicked in. The common culprit is wayward e-liquid; if there's any loose liquid near the connector points on the tank or battery, the device won't fire until it's cleaned up.
Why is my innokin Sceptre vape not working?
If you're still having trouble getting your Innokin Sceptre to work, the next thing that you should do is try removing and reseating the atomizer coil. The most common reason why an Innokin Sceptre doesn't vape is because the atomizer coil is only partially screwed in.
How do you turn on an innokin?
Press the fire button five times quickly to turn the device on. To vape, puff on the tank's mouthpiece while holding the fire button. To adjust the tank's airflow, rotate the collar on the bottom of the tank.
How do I turn off my innokin vape?
The Innokin Endura T18E relies on a manual click system to power on and off. To turn your device on, press the power button three times in succession. To vape, hold the power button down so you can activate the tank/clearomiser.
Why is my innokin t18 not working?
To resolve the issue, make sure that the coil fits snuggly and that the base of the tank is secured tightly. While you are at it, check if the threading on both the coil and tank is clean. If juice or dirt is lodged on the connectors, use a cotton swab or soft cloth to wipe them down with a little rubbing alcohol.
How do you fix a disposable vape that won't hit?
Sometimes, a disposable's failure to hit is simply due to an air bubble in the cartridge that's preventing airflow. If this is the case, try tapping or flicking the side of the cartridge a few times, as this should break it up.
What do the lights mean on innokin adept?
Battery life and charging The battery sign on top of the power bars will light up every time you vape, and its color will indicate battery levels. Green: 60-100% Orange: 20-60% Red: 0-20%
How long does it take to charge innokin?
three hours3 hours. It should take no more than three hours to get your Endura T20S battery from almost empty to full charge.
How do you fix a vape that won't smoke?
Check your tank to make sure you have enough e-liquid. If your tank is completely full but you still have weak vapor, it is possible that your atomizer or coil has been flooded. If this happens, simply take your atomizer apart and clean it with a paper towel or gently blow through it to get the excess liquid out.
How long do innokin go S tanks last?
The device itself is very simple and fairly well made and the 1500mAh battery capacity is more than capable of lasting 12 months considering batteries tend to degrade over time.
How long do innokin go S coils last?
If you take care of the Innokin Go S tank, you should find that it lasts several days – possibly even a week or two – before you need to replace it.
How do I know when my innokin vape is charged?
There is a charging indicator on the kit. This will light up red when on low power, yellow when your battery is on half power and green when it is almost fully charged. When the T18E battery is fully recharged the LED light with turn off.
Why is my innokin Sceptre flashing green?
The green flashing like is an indicator that there is a shortage between the coil and battery.
How long do innokin Sceptre coils last?
But to give you a guide… With the 1.2ohm coil on the higher (boost) power level I got 15 hours in total!
Why is my vape flashing green and not working?
A flashing green light could be indicative of a connection problem between coil (or tank) and battery. To resolve it, ensure the coil is fitted in snugly and that the base of the tank is screwed properly – nice and tight.
How do you fix an auto fired vape?
To fix this problem, you should buy a new coil for your disposable vape pen and replace it with the old one. This will solve the auto firing issue as well as improve the taste of your e-juice.
What is the AFC on a vaporizer?
Many of our vaporizers come bundled with an accompanying tank (atomizer) which features a manually adjustable “AFC”, or airflow control ring. These rings can typically be turned clockwise to adjust the level of airflow you introduce to your coil when you inhale.
Where is the AFC ring on a atomizer?
While most airflow control rings are found on the bottom of our atomizers, there are a few atomizers we have that feature the AFC ring elsewhere, such as the top of the tank. If your device did not come with an included tank, you’ll likely have to adjust your airflow setting in a different way.
What to do if 510 connector is not threaded?
If you are using a vaporizer with a connector that is not 510 threaded, locate the brass colored contacts underneath the pod of your device and apply the same routine to them as you would your 510 connection. While cleaning your atomizer and battery connection, inspect the threads and pins for any damage.
What does it mean when you have a smaller opening on an airflow coil?
With a smaller opening or less holes exposed, the less air you will pull through your coil. This simple principle applies to all of our products that feature adjustable airflow. Product shown: Innokin Ajax tank.
Does the Jem Pen have adjustable airflow?
Some devices such as the Jem Pen will not feature adjustable airflow. This is more common on “AIO”, or all-in-one style devices, as well as some of our more affordable beginner products such as the Glim, Gala and I.O. Q: My screen shows “Check atomizer”.
thefutureisnow Senior Member ECF Veteran
It's an Innokin Endura T18 II. I bought it just a week ago. Everything was working fine until this morning when I tried to fire it and it just blinked three times. I thought maybe there was a problem with the coil, so I put a new one in. It was still blinking. So I made extra sure the coil was in properly. Then it started working again.
Coyote628 Ultra Member ECF Veteran
Battery dead? Well not actually dead, but have you recharged the battery?
thefutureisnow Senior Member ECF Veteran
That's interesting. When I started charging it and tried vaping while it was charging, it worked. The battery wasn't dead before, though. Two of the three lights were fully lit showing that it was at least 60% charged.
Coyote628 Ultra Member ECF Veteran
I dont know that device really, is the battery removable? If so, get new batteries. If not, then maybe vaping it while it was charging did something to it. That's usually not a good idea to use one while its charging as it may not have pass-through function while its charging.
AvaOrchid Ultra Member ECF Veteran
I'm not familiar with the device at all however I find innokin to be a really good company to work with as far as problems and they're fairly responsive on their thread in the Forum just tag one of their brand reps whichever one you see listed and they should give you an idea on how to proceed or maybe there's a quick fix or you're going to have to warranty it.
r77r7r ECF Guru ECF Veteran
Might also not have a spring loaded center post and it got pressed down. Common for ego type Batts.
thefutureisnow Senior Member ECF Veteran
I'm not familiar with the device at all however I find innokin to be a really good company to work with as far as problems and they're fairly responsive on their thread in the Forum just tag one of their brand reps whichever one you see listed and they should give you an idea on how to proceed or maybe there's a quick fix or you're going to have to warranty it.
How to stop your tank from leaking?
Before Vaping Make sure orings, seal and glass are all in good condition and everything is tight. Make sure the coil is fully inserted and lined up correctly, notice cross-threading.
Why am I getting e-liquid in my mouth when I vape?
Please try to vape at an appropriately high wattage which is recommended on the coil during vaping. It may encounter the spitting issue if the liquid on the coil hasn't been atomized on time with low wattage.
Why does my coil or tank have a burnt taste?
If your coil start to have burnt taste within short using time. It may be caused by the following：
Why am I not getting any vapour?
Check that your settings are optimum for the coil installed and ensure it hasn’t reached the end of its natural life. If it has, replace it. Make sure your battery is fully charged and take a slow steady draw.
MVP5 connetor become loose
This issue can be fixed on your own with a proper set of screwdrivers.
Proton connetor become loose
This issue can be fixed on your own with a proper set of screwdrivers.
My Coolfire Z50 stopped working. The screen is stuck. What should I do?
This issue can be fixed by allowing the Z50 to run entirely out of battery, turning the manual switch to "off", then throwing it on a charger until it's reached full charge. Switch the manual switch back to "on", click the firing button 3x to fully turn the device on and see if the issue persists.
What does it mean when your vape pen blinks blue?
(at least 30%) When you pressing power button 3 times continuously, the indicator light blinking blue, it indicates that the vape pen switches to medium mode power output.
Why won't my vape pen hit?
If you find your vape pen won't hit, the reasons and suggestions are as follows: Low battery, charge your vape pen. Remember to press the power button (if your vape pen has) when you are vaping. Loose battery, if your vape pen battery is not built-in, unscrew the battery and re-screw it back in.
T18 light is flashing green - why?
The T18 is flashing green because it is trying to tell you something. It is a simple pen without a screen so it is trying to communicate through this green flashing light.
T18 battery doesn't last long
The Endura T18ii has a built in battery of 1300mAh. This isn't the biggest, but it isn't bad for a pocket sized, low powered pen.
T18 tastes burnt
No one likes the taste or smell of a burnt coil. If your coil has been installed a few weeks then the burnt taste might indicate that it is time to swap it out for a new one. The issues come when you have just installed the coil and it is already burnt.
Becky Spencer-Davies
I'm a writer, runner and biscuit lover. When I'm not writing about pens, pods, mods, coils and juices, you'll find me running in the hills fueled by cookies.
Anyone still having an issue with MVP5 flashlight turning on randomly?
I had this problem after a tank leak. I figured oil got into the battery or the charging ports. I cleaned it out vigously even took it to the shop I got it from and he tried to dry it out. The problem persisted. I let the battery die and recharged it. It went for an entire day without turning on the flashlight.
Innokon Zenith coils problems
Hi all been using my zenith for the last couple of months and my last 3 boxes of coils are burning super quickly.i bought each box separately,not in the same time. Ive been using 0.8 coils from the start,and first box was amazing.15w,same juice as now,and ive had 12-16days of coil life.
Is it worth upgrading from Kroma-R to coolfire Z80?
I've been vaping on the Kroma-R since about a year and i absolutely love it. Now that the coolfire Z80 is out, i wonder if it's actually worth the upgrade.
power button on Innokin ADEPT wont depress
Had problems with my power button being jammed and refusing to depress hence no vape or power controls. Tried everything on Google searches and have finally come up with ultimate solution. I removed the silver cover on the power button. Have to use a fine screwdriver or other device that will fit between the top of the button in the gap.
Innokin Sceptre - How do you prep your coils?
Hey Innokin fans, I would LOVE to know what your process is for preparing your coils for the Sceptre. The coil that came in the device out of the box was loose in the fitting, I filled the tank unknowingly and had dry hit after dry hit.
Coolfire Z80 Mod with Zenith 2 Tank
Hello, Im interested in the new innokin coolfire Z80 mod with the Zennith 2 tank. I'm really liking the features that the coolfire z80 offers but my biggest issue is battery life. I noticed it holds 1 battery at i believe 2200mah which cuts the battery life in half with what I'm currently used to.
Will there ever be a larger (4.5 mL) glass pod released for the Innokin Sensis?
Will there ever be a larger (4.5 mL) glass pod released for the Innokin Sensis?
Zenith Pro O Rings measurements?
Hello! Innokin website doesn't ship to where I'm from so if anyone of you posted the right measurements or some AliExpress link it would super helpful
Big problem with Kroma Z, please help
So I woke up this morning, and went to hit the vape. I pressed the button but nothing happend, the screen was onn, full battery, but nothing was happening. So i plugged it in to charge because I didnt know what else to do and it worked! Until the moment I unplugged it and it started to auto press the button, so i quickly removed the pod to stop it.
Kroma R spittin
I bought Kroma R less than a year ago, since I bought from time to time it just randomly starts to spit back for no clear reason, and whatever I try to do to fix (change coil, change battery, change o ring, etc.) it just randomly fixes itself for few days to return to spit later.