Why is my vape pen not working?
Most of the time, your vape pen isn’t actually broken. More often than not, once you identify the issue with your vape pen, you’ll be able to troubleshoot. Cannabis oil has high viscosity and the concentrate may become stiff. When cannabis oil is cold or settled to one side of the cartridge, it may fail to flow correctly.
Can you over-tighten a vape pen?
Over-tightening your vape pen can sever the connection between the battery and the cartridge. The 510 connection pin on the vape pen needs to connect with the cart to work. If you tighten the vape pen too hard, it can damage this important connection. Over-tightening can also break the rubber O-rings that seal the threading.
How do I Stop my vape pen from burning my oil?
To avoid burning your cannabis oil and damaging your coil, use a lower wattage and a lower temperature setting on your vape pen. Using a higher setting can result in the atomizer vaporizing the oil too fast, and burning the wick. Additionally, taking shorter pulls reduces the heat exposure.
How to fix a vape pen battery that won’t charge?
Heat a pot of water on a stovetop, until steam is produced. Then hold your vape pen over the steam for 20 seconds. This should result in the same effect as the hairdryer method, with your cannabis oil becoming less viscous. Before troubleshooting vape pen battery issues, it’s important to know what kind of battery your vape pen uses.
How do you fix a pen that won't heat up?
2:263:39My Vape Pen Won't Work, Hit, or Heat up. | Fix Vape | Elegant AwareYouTubeStart of suggested clipEnd of suggested clipSometimes the cartridge plates get pushed down as well so you can repeat the same fix for theMoreSometimes the cartridge plates get pushed down as well so you can repeat the same fix for the cartridge plate as you did the battery plate. Use your tool to gently pry up all sides.
Why wont my kind Pen heat up?
It either means your battery needs to be charged, or you are holding the button down too long and your pen is shutting down due to overheating. It could also mean you need a new battery. We recommend holding your button down for less time and seeing if that helps. If not, charge your pen for an hour and check it.
How do you fix a vape that won't smoke?
Check your tank to make sure you have enough e-liquid. If your tank is completely full but you still have weak vapor, it is possible that your atomizer or coil has been flooded. If this happens, simply take your atomizer apart and clean it with a paper towel or gently blow through it to get the excess liquid out.
Why is my vape pen not working?
There are several reasons why your vape pen may not be working properly. Some of these causes are easy fixes, such as oil setting and getting stuck in your cartridge. Others are more technical, like a battery, atomizer or coil issue. Most of the time, your vape pen isn’t actually broken. More often than not, once you identify the issue with your vape pen, you’ll be able to troubleshoot.
How to turn on a vape pen?
Other vape pens use batteries with push-button atomizer activation. To turn these pens on, you’ll need to push the battery button five times quickly and hold the button down when you pull.
How to prolong the life of a vape pen?
Let your vape pen rest between hits to allow the wick to re-saturate with oil. Getting into the habit of cleaning your coil, as well as priming new coils, is another way to extend the lifespan of your coil while avoiding burnt wicks.
How to avoid burning a vape?
To avoid burning your cannabis oil and damaging your coil, use a lower wattage and a lower temperature setting on your vape pen. Using a higher setting can result in the atomizer vaporizing the oil too fast, and burning the wick. Additionally, taking shorter pulls reduces the heat exposure. If you take large draws, you’re more likely to burn your oil.
How to loosen up cannabis oil?
If you don’t have a hairdryer on hand, there are other ways to loosen up your cannabis oil. Heat a pot of water on a stovetop, until steam is produced. Then hold your vape pen over the steam for 20 seconds. This should result in the same effect as the hairdryer method, with your cannabis oil becoming less viscous.
How to get rid of a settled cannabis cart?
A common solution for freeing up your settled cannabis oil involves using a hairdryer to heat the cart. Separate the cart from the battery and set the cart upright. On its low setting, hold a hairdryer about six inches away from the cart. Apply heat for about 30 seconds. When you see bubbles forming, let the cart sit for a few seconds. Then reconnect the cart and take a pull. If your airflow is still obstructed, repeat the process again.
Why is my atomizer not working?
Over-tightening: A common cause of atomizer problems is over-tightening. If you tighten the atomizer with too much force, it can sever the connection with the device . If the connection is intact but it still isn’t working, there may be an issue with the center pin (510 connector).
