Gently Blowing into the mouthpiece Heating the cartridge using a blow drier set at a low temperature, or rubbing the cartridge in between your hands. Dislodging whatever’s clogging the mouthpiece using a small using a safety pin, needle or toothpick.
Full Answer
How to fix a clogged vape pen cartridge?
This list is a variety of steps you can use to fix a vape pen cartridge that is clogging. Take a few puffs, blocking and unblocking the airflow (this will not work with disposable vapes since they have an automatic firing mechanism). If your device has a pre-heat function, use it to heat the concentrate to allow it to move more freely.
Why is my vape pen not working?
Most of the time, your vape pen isn’t actually broken. More often than not, once you identify the issue with your vape pen, you’ll be able to troubleshoot. Cannabis oil has high viscosity and the concentrate may become stiff. When cannabis oil is cold or settled to one side of the cartridge, it may fail to flow correctly.
How to fix a vape pen battery that won’t charge?
Heat a pot of water on a stovetop, until steam is produced. Then hold your vape pen over the steam for 20 seconds. This should result in the same effect as the hairdryer method, with your cannabis oil becoming less viscous. Before troubleshooting vape pen battery issues, it’s important to know what kind of battery your vape pen uses.
Can you over-tighten a vape pen?
Over-tightening your vape pen can sever the connection between the battery and the cartridge. The 510 connection pin on the vape pen needs to connect with the cart to work. If you tighten the vape pen too hard, it can damage this important connection. Over-tightening can also break the rubber O-rings that seal the threading.
How do you fix Smok Novo prongs?
0:386:10*HOW TO FIX* SMOK NOVO 1/2/X VAPE NOT HITTING ... - YouTubeYouTubeStart of suggested clipEnd of suggested clipMove it slightly until the light comes on sometimes it'll work see. It just came on there. So itMoreMove it slightly until the light comes on sometimes it'll work see. It just came on there. So it didn't work I just went back to blinking for lights.
How do you fix a Smok Nord prong?
0:001:54Smok Nord not firing, connection prongs stuck easy fix!! NO FOIL!!YouTubeStart of suggested clipEnd of suggested clipNow when you take off the top my prongs are now up. And they're making a good connection with myMoreNow when you take off the top my prongs are now up. And they're making a good connection with my coil so all I did was I took these tweezers.
What do you do if your Smok vape won't turn on?
If your SMOK vape isn't turning on, it could be a quick fix:Try charging your mod to see if a dead battery is an issue. Plug it into the charger and hope that you forget to recharge after your last use.Check the battery to confirm that it's properly inserted.
How do you open a Smok vape?
1:032:19Smok Nord Unboxing & Setup - YouTubeYouTubeStart of suggested clipEnd of suggested clipFind the fill port on the side and lift the cap fill. It up with your favorite e-juice. Today I'llMoreFind the fill port on the side and lift the cap fill. It up with your favorite e-juice. Today I'll be using mango buy salt shaker. Once your pot is full pulls the cap push the pod into the device.
How do you get a coil off a vape when it's stuck?
Rubber gloves: Put on a pair of washing up gloves and try to unscrew the tank with them on. They increase grip and make it much easier. Rubber bands: Wrap a rubber band around the metal part of the tank. The increased grip will make it easier to unscrew in your hands.
Why is my SMOK Nord not firing?
If your SMOK Nord is failing to fire, first check to make sure the device is fully charged and is on. To turn the device on, simply click the fire button five times and check to see if the LED on the device turns on.
Why is my vape flashing and not working?
When your battery is blinking white, that generally indicates that your battery is not fully connected. A loose battery can disrupt the flow of electricity, preventing your vape from fully charging. Thankfully, the fix is usually as simple as unscrewing your battery and reconnecting it.
Why is my vape not working?
Inspect the battery contact; it may be clogged or coated. If this occurs, wipe the contact portion with a Q-tip soaked in rubbing alcohol, let the terminal dry, reconnect your cartridge to the battery and try it again. Do NOT overtighten your cartridge. Make sure your battery is turned on and fully charged.
How do you reset a vape?
0:000:31How To Do A Factory Reset on Your IQC Vaporizer - YouTubeYouTubeStart of suggested clipEnd of suggested clipOnce the reset is complete the vaporizer will vibrate and button lights will. Turn. Off you.MoreOnce the reset is complete the vaporizer will vibrate and button lights will. Turn. Off you.
How do you take apart a vape?
How to Take Apart a Vape TankTo remove the atomizer coil, unscrew it by twisting counterclockwise.To remove the glass, wiggle it gently to slide it off of the silicone or rubber o-ring holding it in place.To remove the mouthpiece, lift it straight up to pop it out of its socket.
How do you take the top off a Smok vape?
0:243:24SMOK Tank | How to take apart & clean - YouTubeYouTubeStart of suggested clipEnd of suggested clipIf you want to change out your coil. You hold it tight here unscrew your bottom as you can seeMoreIf you want to change out your coil. You hold it tight here unscrew your bottom as you can see there's no ring right in here always make sure it's on correctly.
How do you unlock the power lock on a Smok vape?
Using the Smok M80 is very simple. It features a 5 click lock system to prevent accidental misfires while your device is stored. To lock or unlock the device press the main fire button 5 times in quick succession. You can power your device off to conserve battery life by entering the menu system.
Why does my vape pen leak?
Leaving your vape pen in the car during hot weather can also cause the cartridge to leak. That’s because the cartridge seals expand and creating a passage for vape juice to leak out. Drawing too frequently on your vape pen, known as chain vaping, can also weaken the cartridge seals, causing vape juice to leak out.
Why is my vape pen not producing vapor?
The most likely reason for this is that the firing pin doesn’t have proper contact with the battery, which can happen when the cartridge is screwed in too tight.
Why does my vape pen taste burnt?
If your vape pen produces an unpleasant burnt taste the reason could be either your vape pen’s temperature control is set too high, or the heating coil has residue on it . If your battery’s temperature is adjustable (a feature found in rechargeable vape pens), you can adjust it to a lower setting using its multi-click functions. Start by rapidly pressing button 5 times to turn it on, then press the button rapidly 3 times to alternate between low, medium and high temperatures. If it’s a problem with dirty heating coil, clean it with a cotton bud.
How many times do you have to press the button to turn on a vape pen?
You usually have to click the button five times to turn on the battery. When taking a hit, ensure you hold the button down, otherwise you won’t be able to draw.
Why does my battery light purple?
Battery flashes a purple light 3x when you connect a cartridge. This is to prevent a short circuit that occurs from the cartridge being screwed on too tightly. Try cleaning the electrodes on both the battery & cartridge. If this doesn’t work slowly unscrew the cartridge to see when then button turns solid.
How to remove air bubbles from a cartridge?
One way to remove air bubbles is heating the cartridge with a hair dryer set at a low temperature.
How to clean a clogged mouthpiece?
Dislodging whatever’s clogging the mouthpiece using a small using a safety pin, needle or toothpick. It also helps to regularly clean your cartridge.
What does it mean when your vape tank is flooded?
A flooded tank simply means that you didn’t fill it correctly and now there’s vape juice in places where there shouldn’t be any vape juice. If you encounter this vape pen error, try the following: Remove the drip tip and blow through it — if there’s any liquid in there, this should help you get rid of it.
Why is my e-juice leaking?
When your e-juice is leaking through the airflow holes, it doesn’t have to be that the issue is in the tank — the issue might be in the pressure or the juice that you’re using. Use thicker vape juice — or, you know, don’t leave your vape pen out in the sun because that will cause the juice to become more viscous.
How to clean a septic tank?
Drain the tank — after draining it, soak up the excess juice with a paper tissue. Fill the tank back up (correctly this time), and you should be good to go. Run the tank through hot water — same as above, empty it, clean it, and then run it under hot water. Make sure that everything is dry before using it again.
Does life work like vaping?
Life doesn’t work like that. And neither does vaping. But I’ll tell you this — whatever vape pen problems you’re having, you probably don’t have to run to your local vape shop to get them fixed. In fact, nine times out of ten, you just need a bit of guidance to fix that vape malfunction that’s been bothering you.
Should I empty my vape pen before flying?
Up the wattage so that your wick is not completely soaked even after you take a hit. Empty your tank before flying on a plane — high altitude messes up the pressure in a vape pen. That’s why it’s always best to fly with an empty tank.
Chopstixx Full Member Verified Member
For some reason on my Lambo lava tube the center pin doesn't spring up all the way and doesn't make a full connection to my cartos would a 510 to 510 adapter solve the problem?
justinred Super Member Verified Member ECF Veteran
Some cartos have too long a pin and can push in a mods positive pin. You can try pulling it out a bit with a papercli with a bent "L" end. Same with the cartos, you can also give it a bit of a pull for more contact.
elmattias Resident Miyagi Verified Member ECF Veteran
an adapter wouldn't solve the issue...if a carto isn't making connection neither would an adapter, use some tweezers and pull the center pin out a little, if it's one of those spring loaded center pins then...i don't know.
Chopstixx Full Member Verified Member
Yeh it's spring loaded.. I've tried pulling it out it stays up but when I put on a carto it falls back down
davidfox Full Member Verified Member
I have the same problem but I pulled my center pin and it came out, I carefully stuck it in and it works but it’s no longer spring loaded. is there a solution to it or some designer schematic diagram so I can fix it ? help please!
AttyPops Vaping Master ECF Veteran
I have the same problem but I pulled my center pin and it came out, I carefully stuck it in and it works but it’s no longer spring loaded. is there a solution to it or some designer schematic diagram so I can fix it ? help please!
hotrod3539 Ultra Member Verified Member ECF Veteran
For some reason on my Lambo lava tube the center pin doesn't spring up all the way and doesn't make a full connection to my cartos would a 510 to 510 adapter solve the problem?
Identifying The Issue Through Process of Elimination
First we must identify the issue, which is Delta 8 or other concentrate clogging. Chances are, you've made your way to this article because your vape pen cartridge or disposable vape pen is clogging. To eliminate any other potential issues, make sure that the cartridge still has air flow.
Why Your Vape Pen Cartridge Keeps Clogging
Delta 8 THC and most cannabinoid extracts have a thicker consistency. The concentrate is a lot like candle wax. When it is heated, it flows better, wicks better, and can easily be vaporized. However, when heat isn't being applied to it, it forms into a solid, sticky state that makes it difficult to use.
